Sony MEX-BT2500: Bluetooth function

4 Set the Bluetooth device to search for

Bluetooth function

this unit.

A list of detected devices appears in the

Bluetooth operations

display of the connecting device. This unit is

displayed as “XPLOD” on the connecting

To use the Bluetooth function, the following

device.

procedure is necessary.

1 Pairing:

When connecting Bluetooth devices for the

DR-BT30Q

XPLOD

first time, mutual registration is required. This

XXXXXXX

is called “pairing.” This registration (pairing)

is required only for the first time, as this unit

and the other devices will recognize each

other automatically from the next time. You

can pair up to 8 devices. (Depending on the

5 If Passcode* input is required on the

device, you may need to input a passcode for

display of a connecting device, input

each connection.)

“0000.”

2 Connection

Sometimes pairing allows to connect

automatically. To use the device after pairing

is made, start the connection.

Input passcode.

3 Handsfree talk/Music streaming

XXXX

“0000”

You can call a cellular phone and listen to

music when the connection is made.

This unit and the Bluetooth device memorize

Pairing

each other’s information, and when pairing is

made, the unit is ready for connection to the

First, register (“pair”) a Bluetooth device

device.

(cellular phone, etc.) and this unit with each

other. You can pair up to 8 devices. Once pairing

is established, there is no need for pairing again.

1 Press (OFF).

“ ” flashes and then stays lit after pairing is

Be sure the clock or the demonstration

complete.

appears.

The Auto off function is set, if the unit is

6 Set the Bluetooth device to connect to

turned off and the display disappears, press

this unit.

and hold (OFF) to set the power on.

“ ” or “ ” appears when the connection is

made.

2 Place the Bluetooth device within 1 m

(3 ft) of this unit.

* Passcode may be called “passkey,” “PIN code,” “PIN

number” or “Password,” etc., depending on the

3 Press and hold (EQ/BLUETOOTH) until

device.

“ ” flashes (about 7 seconds).

Note

The unit enters pairing standby mode.

Pairing standby mode is not released until the

connection is made.

flashing

13