Sony KDL-46X3500: 1: Checking the 2: Attaching the stand accessories (except for KDL-

Start-up Guide

1: Checking the

2: Attaching the stand

accessories

(except for KDL-

Mains lead (Type C-6)* (1)

70X3500/52X3500)

Coaxial cable* (1)

PC cable* (1)

Support belt (1) and screws (2)

Stand (1) and screws (4) (only for KDL-46X3500/

40X3500/46X3000/40X3000)

Remote RM-ED010 (1)

Size AA batteries (R6 type) (2)

* Do not remove the ferrite cores.

To insert batteries into the remote

Push and slide to open.

~

• Observe the correct polarity when inserting batteries.

• Do not use different types of batteries together or mix old

and new batteries.

• Dispose of batteries in an environmentally friendly way.

Certain regions may regulate the disposal of batteries.

Please consult your local authority.

• Handle the remote with care. Do not drop or step on it, or

1 Place the TV onto the stand by aligning the

spill liquid of any kind onto it.

screw hole alignment lines over the stand

• Do not place the remote in a location near a heat source, a

as shown.

place subject to direct sunlight, or a damp room.

2 Fix the TV to the stand using the supplied

screws.

To replace the bezel unit

~

(only for KDL-46X3000/40X3000)

• This TV is very heavy, so two or more people should place

The bezel unit can be replaced with others that are sold

the TV on the stand.

separately. However, do not remove the unit except to

• If using an electric screwdriver, set the tightening torque

replace it. For details, see the instructions supplied

at approximately 1.5 N·m (15 kgf·cm).

with bezel units.

GB

4