Sony KDL-40X2000: 7: Auto-tuning the TV

When the TV is in standby mode (the 1 (standby)

indicator on the TV (front) is red), press TV "/1

Start-up Guide

7: Auto-tuning the TV

on the remote to switch on the TV.

3 Press F/f/G/g to select the language

The TV will search for and store all available TV

displayed on the menu screens, then press

channels.

.

4 Press F/f to select the country/region in

which you will operate the TV, then press

2

.

2

4

1 Before you start auto-tuning the TV, insert

a pre-recorded tape into the VCR

connected to the TV (page 5) and start play

back.

The video channel will be located and stored on

the TV during auto-tuning.

If the country/region in which you want to use the

If no VCR is connected to the TV, skip this step.

TV does not appear in the list, select “-” instead of

2 Press G/g to select “OK”, then press .

a country/region.

The message confirming the TV start auto-tuning

appears on the screen, then go to “7: Auto-tuning

the TV”.

The TV starts searching for all available digital

channels, followed by all available analogue

channels. This may take some time, please be

patient and do not press any buttons on the TV or

remote.

If a message appears for you to confirm the aerial

connection

No digital or analogue channels were found.

Check the aerial connection and press G/g to

select “Yes”, then press to start auto-tuning

again.

Continued

GB

7

3 When the Programme Sorting menu

appears on the screen, follow the steps of

“Programme Sorting” (page 35).

If you do not change the order in which the analogue

channels are stored on the TV, go to step 4.

4 Press MENU to exit.

The TV has now tuned in all the available channels.

Note

When a digital broadcast channel cannot be received, or

when selecting a region in which there are no digital

broadcasts in step 4 (page 7) under “6: Selecting the

language and country/region”, the time must be set after

performing step 3.

GB

8