Sony Bravia KDL-32D3010: Detaching the Table-

4 Press F/f to select the country/region in

9 Press MENU to exit.

which you will operate the TV, then press

The TV has now tuned in all the available channels.

.

~

When a digital broadcast channel cannot be received, or

when selecting a region in which there are no digital

broadcasts in step 4 (page 6), the time must be set after

performing step 9.

To tune the TV for digital cable connection

1 Press F/f to select “Scan Type”, then

press .

2 Press F/f to select “Quick Scan” or “Full

Scan”, then press .

If the country/region which you want to use on the

“Quick Scan”: Channels are tuned according to

TV does not appear in the list, select “-” instead of

the cable provider’s information within the

a country/region.

broadcast signal. The recommended setting for

“Frequency”, “Network ID” and “Symbol Rate” is

“Auto” unless your cable provider has supplied

actual values to use. “Quick Scan” is

Auto-tuning the TV

recommended for fast tuning when this is

supported by your cable provider.

“Full Scan”: All available channels are tuned and

5 Before you start auto-tuning the TV, insert

stored. This procedure may take some time. This

a pre-recorded tape into the VCR

option is recommended when “Quick Scan” is not

connected to the TV (page 4) and start play

supported by your cable provider.

back.

For further information about supported cable

The video channel will be located and stored on

providers, refer to the support web site:

the TV during auto-tuning.

http://support.sony-europe.com/TV/DVBC

If no VCR is connected to the TV, skip this step.

3 Press G/g/f to select “Start”.

6 Press G/g to select “OK”, then press .

The TV starts searching for channels. Do not press

any buttons on the TV or remote.

~

Some cable providers do not support “Quick Scan”. If no

channels are detected using “Quick Scan”, perform “Full

Scan”.

7 Press F/f to select “Antenna” or “Cable”,

then press .

Detaching the Table-

If you select “Cable”, the screen for selecting the

scan type appears. See “To tune the TV for digital

Top Stand from the TV

cable connection” on page 6.

The TV starts searching for all available digital

~

channels, followed by all available analogue

Do not remove the Table-Top Stand for any reason other than

channels. This may take some time, so do not

to wall-mount the TV.

press any buttons on the TV or remote while

proceeding.

If a message appears for you to confirm the aerial

connection

No digital or analogue channels were found.

Check all the aerial connections and press to

start auto-tuning again.

8 When the Programme Sorting menu

appears on the screen, follow the steps of

“Programme Sorting” on page 31.

If you do not wish to change the order in which the

analogue channels are stored on the TV, go to next

step.

GB

6