Sony DSC-W710 Black: Notes on using the camera

Notes on using the camera: Sony DSC-W710 Black

Notes on using the camera

On use and care

Avoid rough handling, disassembling, modifying, physical shock, or impact such as

hammering, dropping, or stepping on the product. Be particularly careful of the lens.

Notes on recording/playback

Before you start recording, make a trial recording to make sure that the camera is

working correctly.

GB

The camera is neither dust-proof, nor splash-proof, nor water-proof.

Avoid exposing the camera to water. If water enters inside the camera, a

malfunction may occur. In some cases, the camera cannot be repaired.

Do not aim the camera at the sun or other bright light. It may cause the

malfunction of the camera.

If moisture condensation occurs, remove it before using the camera.

Do not shake or strike the camera. It may cause a malfunction and you may not be

able to record images. Furthermore, the recording media may become unusable or

image data may be damaged.

Do not use/store the camera in the following places

In an extremely hot, cold or humid place

In places such as in a car parked in the sun, the camera body may become

deformed and this may cause a malfunction.

Storing under direct sunlight or near a heater

The camera body may become discolored or deformed, and this may cause a

malfunction.

In a location subject to rocking vibration

Near a location that generates strong radio waves, emits radiation or is strongly

magnetic place. Otherwise, the camera may not properly record or play back

images.

In sandy or dusty places

Be careful not to let sand or dust get into the camera. This may cause the camera to

malfunction, and in some cases this malfunction cannot be repaired.

On carrying

Do not sit down in a chair or other place with the camera in the back pocket of your

trousers or skirt, as this may cause malfunction or damage the camera.

Notes on the screen

The screen is manufactured using extremely high-precision technology so over

99.99% of the pixels are operational for effective use. However, some tiny black

and/or bright dots (white, red, blue or green) may appear on the screen. These dots

are a normal result of the manufacturing process, and do not affect the recording.

GB

25

On camera’s temperature

Your camera and battery may get hot due to continuous use, but it is not a

malfunction.

On the overheat protection

Depending on the camera and battery temperature, you may be unable to record

movies or the power may turn off automatically to protect the camera.

A message will be displayed on the screen before the power turns off or you can no

longer record movies. In this case, leave the power off and wait until the camera and

battery temperature goes down. If you turn on the power without letting the camera

and battery cool enough, the power may turn off again or you may be unable to

record movies.

On charging the battery

If you charge a battery that has not been used for a long time, you may be unable to

charge it to the proper capacity.

This is due to the battery characteristics, and is not a malfunction. Charge the battery

again.

Warning on copyright

Television programs, films, videotapes, and other materials may be copyrighted.

Unauthorized recording of such materials may be contrary to the provisions of the

copyright laws.

No compensation for damaged content or recording failure

Sony cannot compensate for failure to record or loss or damage of recorded content

due to a malfunction of the camera or recording media, etc.

Cleaning the camera surface

Clean the camera surface with a soft cloth slightly moistened with water, then wipe

the surface with a dry cloth. To prevent damage to the finish or casing:

Do not expose the camera to chemical products such as thinner, benzine, alcohol,

disposable cloths, insect repellent, sunscreen or insecticide.

Maintaining the LCD monitor

Hand cream or moisturizer left on the screen may dissolve its coating. If you get

any on the screen, wipe it off immediately.

Wiping forcefully with tissue paper or other materials can damage the coating.

If fingerprints or debris are stuck to the screen of the LCD monitor, we

recommend that you gently remove any debris and then wipe the screen clean with

a soft cloth.

GB

26

Оглавление