Главная > Инструкция к Прочим персональным приборам Panasonic ES8044 > Charge with charging

Panasonic ES8044: Charge with charging

Charge with charging: Panasonic ES8044

The battery capacity monitor will all

Charge with charging

illuminate and the charge status lamp

stand

will blink after charging is completed

(see fig. 1 (B))

(see fig. 2 (A)).

To charge with the charging stand,

10 minutes after charging is com-

connect the power cord to the charg-

pleted, the battery capacity monitor

ing stand. Place the shaver into the

will extinguish and the charge status

stand, and plug the adaptor to the

lamp will continue to blink (see fig. 2

AC outlet.

(B)).

You can always store your shaver in

You can fully charge the shaver in 1

the charging stand to maintain full

hour if the LED display shows “low”

battery capacity. This shaver cannot

(low).

be overcharged.

The battery capacity monitor indi-

cates the charge remaining in the

Using your shaver

battery in 3 levels (high/mid/low). The

unit can be used once or twice more

Caution – The system outer foil is

after the “low” (low) starts to blink.

very thin and can be damaged if

(Differs depending on the use situa-

handled improperly. Before each

tion.)

use, always check the foil for dam-

age. To avoid personal injury, do

[for ES8043]

not use if the foil or other parts of

The charge status lamp will glow

the shaving head is damaged.

when the shaver is being charged. It

will blink when the charging is com-

Disconnect the power cord from the

pleted (see fig. 2 (D)).

shaver, and push the On/Off switch

You can fully charge the shaver in 1

to turn the shaver on.

hour if the low battery indicator blinks

If you push and hold the On/Off

(see fig. 2 (C)).

switch for more than 2 seconds, it

The unit can be used once or twice

will activate the turbo mode for

more after the low battery indicator

“sonic” vibration cleaning.

starts to blink.

(see “Cleaning your shaver”)

Caution:

A full charge will supply enough

Shaving with “sonic” vibration may

power for approx. 14 shaves (3 min-

damage your skin. Please turn it

utes per shave for a normal beard).

off and on again to deactivate the

Before travelling, charge it fully for 1

turbo mode.

hour if you will not be taking the adap-

tor with you.

In case your shaver is without charge,

you may quick charge it for 1 shave

in about 5 minutes.

8

(gel, soap, cream, etc.). Do not put a

Do not place fingers on the On/Off

thick layer of shaving foam as it may

switch during use.

affect shaver’s performance. If the

This may cause the shaver to stop

shaving head is clogged with foam,

during use or change it to the

simply rinse it under running water.

“sonic” vibration cleaning mode.

Place your finger on the finger rest

Using the trimmer

during use.

(see fig. 6)

Hold the shaver at a right angle (90°)

Slide the trimmer handle up to open

to your skin (see fig. 3). Start out

the trimmer.

shaving by applying gentle pressure

Place the trimmer at a right angle to

to your face. Stretch your skin with

your skin and move it downward to

your free hand and move the shaver

trim sideburns.

back and forth in the direction of your

beard. You may gently increase the

Cleaning your shaver

amount of pressure as your skin be-

(see fig. 7)

comes accustomed to this shaver.

Warning – To prevent electric

Applying excessive pressure does

shock or personal injury, discon-

not provide a closer shave.

nect the power cord from the

Pivot action selector

shaver before cleaning with water.

(see fig. 4)

Use the pivot action selector to

For cleanliness and convenience, we

choose the shaving mode, “soft”

recommend that you clean your

(soft) and “lock” (lock) based on your

shaver with water and a liquid hand

shaving preference.

soap. Regular cleaning will keep your

The pivot action can be changed

shaver in good condition while pre-

whether the switch is turned on or off.

venting odors or bacteria from devel-

oping, and maintain the cutting per-

System outer foil

formance.

(see fig. 5)

With the system outer foil in place,

System outer foil has a slit blade (a)

apply some hand soap onto the outer

between 2 foils (b). They move up

foil.

and down independently to follow the

Push and hold the On/Off switch

contours of your face.

more than 2 seconds to activate the

The slit blade catches and cuts

turbo mode for “sonic” vibration

longer and lying hairs easily.

cleaning.

For wet shaving

At the same time, the lamps of the

Battery capacity monitor (ES8044) or

Put a thin layer of shaving foam on

Low battery indicator/Charge status

your face which works as a lubrica-

lamp (ES8043) will flash around ran-

tor. Shaving foam is the most suit-

domly.

able among many other shaving aids

9

P006-039ES804443EU 05.2.21 11:15 ページ6

76

Оглавление

Топ 10 инструкций

Другие инструкции

Panasonic ES7109 Panasonic ES7109 Panasonic ES7101 Panasonic ES7101 Panasonic ES7036 Panasonic ES7036 Panasonic ES8162 Panasonic ES8162