Panasonic ES4025: инструкция

Before use

K Charging adaptor

This Wet/Dry shaver can be used for

L Charge indicator lamp

wet shaving with shaving lather or for

M Cleaning brush

dry shaving. You can use this water-

N Travel pouch

tight shaver in the shower and clean

it in water. The following is the sym-

Charging

bol of Wet shaver. The symbol means

(see fig. 2)

that hand-held part may be used in

Switch the shaver off and set it firmly

a bath or shower.

into the charging adaptor. Keep the

adaptor level.

Plug the adaptor into an AC outlet.

The charge indicator lamp will glow

red and it will stay on until the shaver

Treat yourself to wet lather shaves

is removed from the adaptor.

for at least three weeks and notice

You can fully charge the shaver in 8

the difference. Your Panasonic Wet/

hours if it seems to be losing speed.

Dry shaver requires a little time to get

A full charge will supply enough

used to because your skin and beard

power for about 7 shaves (3 minutes

need about a month to adjust to any

per shave for a normal beard).

new shaving method.

Before traveling, charge it fully for 8

Charge the shaver for at least 16

hours if you will not be taking the

hours before using it for the first time

charging adaptor with you.

or when it has not been in use for

more than 6 months.

For a better shave

Put a thin layer of shaving foam on

Parts identification

your face which works as a lubricant.

(see fig. 1)

Shaving foam is the most suitable

A Protective cap

among many other shaving aids (gel,

soap, cream, etc.). Do not put a thick

B Outer foil

layer of shaving foam as it may af-

C Outer foil release buttons

fect the shaver’s performance. If the

D Foil frame

shaving head is clogged with foam,

simply rinse it under running water.

E Inner blades

Depress the switch lock button and

F Foil frame release buttons

slide the On/Off switch upward to turn

G On/Off switch

the shaver on. Hold the shaver at a

right angle (90°) to your skin (see fig.

H Switch lock button

3). Start out shaving by applying gen-

I Trimmer

tle pressure to your face. Stretch your

J Trimmer handle

skin with your free hand and move

the shaver back and forth in the di-

6

mium battery.

the ES4025/ES4026/ES4027

Please make sure that the battery is

shaver.

disposed of at an officially assigned

• The supply cord of the charging

location, if there is one in your country.

adaptor cannot be replaced; if the

cord is damaged, the entire charger

How to remove the built-in

should be discarded.

rechargeable battery before

disposal of the shaver

• Dry the shaver completely before

(see fig. 9)

setting it in the charging adaptor.

The battery in this shaver is not in-

• Keep the charging adaptor away

tended to be replaced by consum-

from water and handle it only with

ers. However, the battery may be re-

dry hands. Do not use an extension

placed at an authorized service

cord to connect the charging adap-

center. The procedure described be-

tor to an outlet.

low is intended only for removal of

• Grip the plug when disconnecting

the rechargeable battery for the pur-

the charging adaptor from a recep-

pose of proper disposal.

tacle; tugging on the cord may dam-

1. Remove the protective cap, outer

age it.

foil frame and inner blades.

• Store the charging adaptor and its

2. Remove the 2 screws (a) on the

cord set in a dry area where it will

top.

be protected from damage.

3. Grasp the bottom of the unit and

• The outer foil is very thin. If han-

the button area (b) located on the

dled improperly, it can be easily

left and right, and pull the button

damaged. To avoid personal injury,

area away from the main unit.

do not use the shaver if it has a

4. Remove the 2 screws (c) located

damaged foil or inner blades.

inside the main unit’s case.

• Wash the shaver in tap water. Do

5. Grasp the top part (d) and bot-

not use salt water or boiling water.

tom part (e) of the main unit, and

Also, do not use cleaning products

pull them both out.

that are designed for toilets, bath-

6. Remove the battery (f) from the

rooms or kitchen appliances. Do

chassis.

not submerge the shaver for a long

time.

Caution

• Do not wipe any part of the shaver

• Do not charge the shaver where the

with thinner, benzine or alcohol.

temperature is below 0°C (32°F) or

Clean it by using a cloth dampened

above 40°C (104°F), where it will

with soapy water.

be exposed to direct sunlight or a

• Do not take the housing apart as

heat source, or where there is a lot

this can affect the watertight con-

of moisture.

struction.

• Use only the included shaver

• If the shaver is not working prop-

charging adaptor RE3-68 to charge

erly, have it inspected at the place

8