Panasonic ES7058: инструкция

Operating Instructions

Rechargeable Shaver

Model No. ES7058

English 2

Dansk 62

Ĉesky 122

Deutsch 12

Portugês 72

Magyar 132

Français 22

Norsk 82

Română 142

Italiano 32

Svenska 92

Русский 152

Nederlands 42

Suomi 102

Türkçe 162

Espanõl 52

Polski 112

Українська 172

Before operating this unit, please read these instructions completely.

damaged. If you clean the shaver with water, do not use salt

Important

English

water or hot water. Do not soak the shaver in water for a long

period of time. Wipe it with a cloth dampened with soapy water.

Before use

Do not use thinner, benzine or alcohol.

This Wet/Dry shaver can be used for wet shaving with shaving

Storing the shaver

lather or for dry shaving. You can use this watertight shaver in

Disconnect the power cord when storing the shaver. Do not

the shower and clean it in water. The following is the symbol of

bend the power cord or wrap it around the shaver. Do not leave

Wet shaver. The symbol means that hand-held part may be

this shaver within the reach of small children. Keep these

used in a bath or shower.

operating instructions in a safe place.

Self-cleaning recharger

Do not clean the adaptor or the self-cleaning recharger in water

as it will damage them or cause an electric shock. Do not

remove the shaver from the self-cleaning recharger while using

a course that includes the “Dry” function. A heater is used so the

Treat yourself to wet lather shaves for at least three weeks and

area around the blades becomes extremely hot and you may

notice the difference. Your Panasonic Wet/Dry shaver requires a

burn yourself.

little time to get used to because your skin and beard need

Place the self-cleaning recharger on a level and stable surface.

about a month to adjust to any new shaving method.

Otherwise the cleaning liquid may spill and discolor leather

Using the shaver

products or other surfaces. Wipe it immediately. The self-

Caution - The outer foil is very thin and can be damaged if not

cleaning recharger cleans the inner blades and the system

used correctly. Check that the foil is not damaged before using

outer foil. Brush or wash with water to remove beard trimmings

the shaver. Do not use the shaver if the foil etc. is damaged as

in other areas.

you will cut your skin.

Charging the shaver

Only use the supplied power cord and recharger to charge the

SPECIFICATIONS

shaver. Plug in the adaptor into a household outlet where there

Power source: 100-240 V AC, 50-60 Hz

is no moisture and handle it with dry hands. The shaver and the

(Automatic voltage conversion)

recharger may become warm during use and charging.

Motor voltage: 2,4 V DC

However, this is not a malfunction. Do not charge the shaver

Charging time: 1 hour

where it will be exposed to direct sunlight or other heat sources.

This product is intended for household use only.

Hold the adaptor when disconnecting it from the household

Airborne Acoustical Noise;

outlet. If you tug on the power cord, you may damage it. Contact

In shaving mode: 62 (dB (A) re 1 pW)

an authorized service center if the power cord gets damaged.

In trimmer mode: 63 (dB (A) re 1 pW)

Cleaning the shaver

Disconnect the power cord from the shaver before cleaning it to

prevent electric shock. Keep both the inner blades inserted. If

only one of the inner blades is inserted, the shaver may be

2

Parts identification

English

3



high



mid



low

charge



status







�

 Protective cap

 On/Off switch

 System outer foil

 Battery capacity monitor

 System outer foil release

 high

buttons

 mid

 Foil frame

 low

 Inner blades

 Charge status lamp

 Foil frame release buttons

 Trimmer

 LED display

 Trimmer handle

 Adaptor

 Clean lamp

 Power cord

 Dry lamp

 Self-cleaning recharger

 Charge lamp

(Referred to as the

 Status lamp

“Recharger”.)

 Select button

 Detergent cartridge

 Cleaning tray

 Water tank

 Feed water line

 Socket

 Travel pouch

 Arm

 Cleaning brush

 Water tank cap

Operating environment for the self-cleaning

recharger

Operating temperature: 15-35 °C (59-95 °F)

Operating humidity: Less than 95%

• If you use the self-cleaning recharger in temperatures outside the

above range, the following problems may occur.

- The time it takes to charge the shaver increases.

- The recharger stops functioning.

- The lifespan of the rechargeable battery shortens. (Only when

you use the recharger in lower temperatures.)

• If the charge status lamp does not glow, wait for a short while

until it glows.

• Depending on the environment, the shaver may not dry even if

you select a course that includes the “Dry” function. In this case,

wipe off any drops of water with a dry cloth.

English

Charging with the self-cleaning recharger

Thoroughly wipe off any drops of water on or around the recharger so that it is dry before charging it.

You can charge without the recharger.

Page 5

4

Charge

Attach the detergent

Pull up the arm until it

• You can keep the shaver attached to the recharger, or

cartridge and the

clicks.

connected to the adaptor, when not using it to maintain full

water tank to the

battery capacity. You cannot overcharge the shaver.

Remove the protective

• A special plug adaptor may be required in some areas.

self-cleaning

cap and then attach the

recharger.

shaver.

Page 6

• Turn the shaver off before

Insert the appliance

attaching.

• Check that the outer foil is not

plug.

deformed or damaged when you

are attaching the shaver.

Plug in the adaptor.

Push down the arm

until it clicks.

• The charge status lamp glows and

charging starts.

• Charging is completed when the

charge status lamp blinks.

(Max. 1 hour later)

About the lamp

10 minutes after

charging is

completed

English

Blinks red once

every 2 seconds.

• “high/mid/low” go

out.

5

After charging is

completed

Blinks red once

every second.

While charging

Glows red.

During use

The battery capacity is low when “low” blinks.

• A full charge will supply enough power for approx. 14 shaves of

3 minutes each.

Using the shaver

Shave

Depress the

Hold the shaver as

switch lock

illustrated above and

button and slide

shave.

the On/Off

• You can shave 1 to 2 times after “low” blinks.

switch upwards.

(This will differ depending on usage.)

• Start out shaving by applying gentle pressure to your face.

Stretch your skin with your free hand and move the shaver back

and forth in the direction of your beard. You may gently increase

the amount of pressure as your skin becomes accustomed to

this shaver. Applying excessive pressure does not provide a

closer shave.

Charging without the self-cleaning recharger

Using the trimmer

1. Insert the appliance plug into

Slide the trimmer handle up.

the shaver.

Place at a right angle to your

2. Plug in the adaptor into a

skin and move downwards to

household outlet.

trim your sideburns.