Panasonic S73MK1E5A: Maintenance

Maintenance: Panasonic S73MK1E5A

Maintenance

Indoor unit

WARNING

For safety, be sure to turn the air conditioner off and dis-

connect the power before cleaning.

(Otherwise, electric shock or injury may result because

Wipe with a soft cloth.

the fan is rotating at high speed.)

(If it is very dirty, use

Do not pour water on the indoor unit.

a cloth moistened with

(This may damage the internal components and cause

water.)

an electric shock hazard.)

Do not attempt to clean inside the unit by yourself.

Refer to the section "Care and Cleaning" in the Installation

CAUTION

Instructions.

Never use solvents or harsh chemicals. Also, do not wipe

plastic parts using very hot water.

(This may cause deformation or change in colour.)

Some metal edges and ns are sharp. Be careful when

you clean those parts.

(Injury may result.)

Use a rm stool or ladder when cleaning an indoor unit

installed in high locations.

The internal coil and other components of the outdoor unit

must be cleaned periodically.

• Consult your dealer or service center.

Before Requesting Services

Symptom Cause Action

The air

Power failure or after power failure Press the power ON/OFF button on the remote controller.

conditioner does

• If the breaker is turned off, turn the power on.

not operate

The operation (power) button is turned off.

• If the breaker has been tripped, consult your dealer

although the

without turning it on.

power is turned

on.

Fuse blow out. Contact your dealer.

The air intake or air outlet of indoor and

Remove the dust.

outdoor units is clogged with dust.

The wind speed switch is set to “Low”. Change to “High” or “Strong”.

Improper temperature settings

The room is exposed to direct sunlight in

Poor cooling

See “Tips for Energy Saving”. (P.7)

cooling mode.

or heating

Doors or windows are open.

performance

The air lter is clogged. See “Maintenance”. (P.8)

Too many heat sources in the room in

Use minimum heat sources and in a short time.

cooling mode.

Too many people in the room in cooling

Lower the temperature setting or change to “High” or

mode.

“Strong”.

If your air conditioner does not work properly even after checking each item of

“Before Requesting Services” and “Troubleshooting”

Stop the operation immediately and turn the power off. Then contact your dealer and report the serial number and symptom.

You also report if the inspection mark

and the letters E, F, H, L, P in combination with numbers appear on the LCD of the

remote controller.

Never repair the air conditioner by yourself since it is very dangerous for you to do so.

8

OI00284010EUall.indb8OI00284010EUall.indb8 2013/11/2914:35:352013/11/2914:35:35

Оглавление