Panasonic S160MU1E5A: Names of Parts

Names of Parts

INDOOR UNIT

Water drain

Air outlet duct *

Bolt anchor *

Suspension bolt *

Indoor unit

Ceiling panel

(optional)

Ceiling material *

Air outlet

(4 locations)

Air-outlet grille *

Air intake grille

* Field supplied

(air intake)

F2 type

(Low Silhouette Ducted)

ENGLISH

U1 type

(4-Way Cassette)

Air outlet

Water drain

Air intake grille

(air intake)

T2 type

(Ceiling)

Optional

Wireless Remote Controller

Timer Remote Controller

High-spec Wired Remote Controller

Model No.

Model No.

Model No.

CZ-RWSU2 (U1 type)

CZ-RTC2

CZ-RTC3

CZ-RWST3 (T2 type)

CZ-RWSC3

For all indoor

For all indoor

(For all indoor units)

units

units

Read the operating instructions included with the Remote Controller.

Operation Mechanism



Heating performance



‘‘DRY’’ operation

z

Since this air conditioner utilizes outside air for heating,

z

Once the room temperature reaches the level that was

its heating performance deteriorates as outside tempera-

set, the outdoor unit repeats the cycle of turning on and

ture decreases.

off automatically.

(Due to heat pump system)

z

When the outdoor unit is turned off, the indoor unit fan

→In that case, use another heating appliance.

will stop, too.

(To prevent the humidity in the room from rising again)



Defrosting

z

When the room temperature is more likely to reach the

z

This appliance may start defrosting operation to melt

level that was set, the fan speed is set to ‘‘breeze’’ (light

frost formed in the outdoor unit.

wind) automatically.

1

Defrosting starts

: The indoor unit fan stops (or the

z

‘‘DRY’’ operation is not possible if the outdoor tempera-

speed becomes extremely slow).

ture is 15 °C or less.

→”

” (STANDBY) appears.

2

Heating operation resumes after several



Should the power failure occurs while the

minutes

: The indoor unit fan remains stopped (or

unit is running

it will run at a very slow speed) until the indoor heat

When the unit automatically resumes operation after

exchanger coil warms up suf ciently.

temporary power failure, it uses the same settings before

→ ”

” (STANDBY) is shown.

the power was cut off.

3

Defrosting is complete

: The indoor unit fan starts

operation.

→ ”

” (STANDBY) disappears.

5

OI_F569617_EU_L.indb 5 2013-12-17 17:57:39