Panasonic DMWMCTZ40E: 2 Check the O-ring.

2 Check the O-ring.

•

Check that there is no dirt, sand, hair, dust, salt crystals, lint or grease on

the O-ring. If you find any of these, remove them with a soft, dry cloth.

1 Dirt 3 Hair 5 Salt crystals

2 Sand 4 Dust 6 Lint

• There may be dirt on the O-ring that you cannot see. Check if there is any

dirt by rubbing your finger over the O-ring.

• Be careful not to leave any fibers from the dry cloth on the O-ring when

wiping it.

• Check that the O-ring is not ripped, twisted, squashed, frayed or scratched

and that there is no sand sticking to it. Replace the O-ring in these cases.

7 Ripped 9 Squashed ; Scratched

8 Twisted : Frayed < Sand

3 Inspect the O-ring groove.

•

Grains of sand or hardened salt crystals may get into the O-ring groove.

Remove them carefully with an air spray or a cotton swab. If you use a

cotton swab, be careful not to leave any fibers from it in the O-ring groove.

• Inspect the front case groove as well as the rear case (side where O-ring

is set) groove.

(ENG) VQT4V81

9

DMW-MCTZ35&40_PP&E-VQT4V81.book 9 ページ ２０１３年１月７日　月曜日　午後２時７分