Panasonic TYST65PV500: 3 Remove the cable cover set screws on the

Cable binding instructions

Preventing the plasma television from failing over

Tip-prevention parts

Tap screws (4) Wood screws (4) Bands (4)

Attaching to a TV stand Attaching to a wall

3 Remove the cable cover set screws on the

plasma television (used for transport).

English

4 Remove the cable cover from the plasma

television.

Press the two hooks (right and left) at the cover top, and then

pull the cover forward to remove it.

5 Attach the clampers to the fl oor-mounted

Cable cover set screws

stand.

Attach the stand clampers (right and left).

6 Connect the cable and power cord.

7 Use the clampers to bind the cable and

power cord.

8 Reattach the cable cover to the plasma

Clampers

television.

Cable Power cord

Insert the two clips into the cover bottom, and then insert the

top hooks.

■ Attaching and removing the cable cover

Removal Fitting

Front face

Notes:

Locate the wood screw at the

• Securely attach to a wall, pillar or similarly solid

centre of the material width.

structural feature using separately- obtained

products such as cords or chains of adequate

Note:

strength.

There are four holes in the base for the screws holding the

• Secure in the side at two locations each on the

bands.

left and right.

The picture shown is illustrative purposely only and may differ slightly from the actual product.

TY-ST65PV500689.indb4TY-ST65PV500689.indb4 2005/09/1310:47:002005/09/1310:47:00