Panasonic HHS12035E: Attaching/Detaching the Lens

VQT4G29_E.book 6 ページ ２０１２年５月２３日　水曜日　午前８時１８分

∫ Detaching the Lens

Attaching/Detaching the Lens

≥ Check that the camera is turned off.

≥ Refer also to the camera’s operating instructions

While pressing on the

for attaching and detaching the lens.

lens release button D,

∫ Attaching the Lens

rotate the lens toward

≥ Check that the camera is turned off.

the arrow until it stops

1 Turn the lens rear cap

and then remove.

to detach it.

• Attach the lens rear cap so

A: Lens Rear Cap

that the lens contact point does not get

scratched.

• Attach the body cap to the camera so no dirt or

dust will get inside the main unit.

2 Align the lens fitting

∫ Attaching and Detaching the Lens Cap

marks B (red marks) on

the camera body and the

Pinch the lens cap

lens and then rotate the

as shown in the

lens in the direction of

figure to attach or

the arrow until it clicks.

• Do not press the lens release

detach.

button C when you attach a lens.

• Be careful not to lose

• Do not try to attach the lens when holding it at an

the lens cap.

angle to the camera body as the lens mount may

get scratched.

• Check that the lens is attached correctly.

6

VQT4G29

VQT4G29_E.book 7 ページ ２０１２年５月２３日　水曜日　午前８時１８分

∫ Attaching the Lens Hood

• Hold the short sides of the flower shape lens

hood when attaching or detaching it.

(Supplied Accessory)

• When taking pictures with the flash with the lens

Insert the lens hood into

hood attached, the lower portion of the screen

the lens with the short

may turn dark (vignetting effect) and the control

sides at the top and

of the flash may be disabled because the photo

bottom, and turn in the

flash may be obscured by the lens hood. We

direction of the arrow

recommend detaching the lens hood.

until it stops.

• When using the AF assist lamp in the dark,

E: Fit to the mark

detach the lens hood.

∫ Temporarily Storing the Lens Hood

∫ Attaching Filters

≥ Vignetting may occur if using 2 or more

1 Turn the lens hood in the

MC protectors (optional: DMW-LMCH58),

direction of the arrow to

PL filters (optional: DMW-LPL58) or ND filters

detach it.

(optional: DMW-LND58), or if using thick

protectors and/or filters.

≥ The filter may become impossible to remove if

excessively tightened, so please refrain from

2 Reverse the lens hood

tightening it too strongly.

and then attach it in the

≥ It is possible to attach the lens cap with the filter

same way as shown

already attached.

previously.

≥ You cannot attach a conversion lens or adaptor to

this lens. A filter may be used, but attaching any

other element may cause damage to the lens.

7

VQT4G29