Panasonic HHS35100E: Attaching/Detaching the Lens

VQT4G75_E.book 6 ページ ２０１２年９月１１日　火曜日　午後７時３５分

∫ Detaching the Lens

Attaching/Detaching the Lens

≥ Check that the camera is turned off.

≥ Refer also to the camera’s operating instructions

While pressing on the

for attaching and detaching the lens.

lens release button D,

∫ Attaching the Lens

rotate the lens toward

≥ Check that the camera is turned off.

the arrow until it stops

1 Turn the lens rear cap

and then remove.

to detach it.

• Attach the lens rear cap so

A: Lens Rear Cap

that the lens contact point does not get

scratched.

• Attach the body cap to the camera so no dirt or

dust will get inside the main unit.

2 Align the lens fitting

∫ Attaching and Detaching the Lens Cap

marks B (red marks) on

the camera body and the

Pinch the lens cap

lens and then rotate the

as shown in the

lens in the direction of

figure to attach or

the arrow until it clicks.

• Do not press the lens release

detach.

button C when you attach a lens.

• Be careful not to lose

• Do not try to attach the lens when holding it at an

the lens cap.

angle to the camera body as the lens mount may

get scratched.

• Check that the lens is attached correctly.

6

VQT4G75

VQT4G75_E.book 7 ページ ２０１２年９月１１日　火曜日　午後７時３５分

∫ Attaching the Lens Hood

2 Reverse the lens hood

(Supplied Accessory)

and then attach it in the

same way as shown

1

Align the fitting mark

E

on the lens

previously.

hood with the mark on the tip of the lens.

• When taking pictures with

2 Turn the lens hood in the direction of

the flash with the lens hood

the arrow until it stops, and align the

attached, the lower portion of

stop mark F on the lens hood with

the screen may turn dark (vignetting effect) and

the mark on the tip of the lens.

the control of the flash may be disabled because

the photo flash may be obscured by the lens

hood. We recommend detaching the lens hood.

• When using the AF assist lamp in the dark,

detach the lens hood.

∫ Attaching Filters

≥ Vignetting may occur if using 2 or more

MC protectors (optional: DMW-LMCH58),

PL filters (optional: DMW-LPL58) or ND filters

(optional: DMW-LND58), or if using thick

protectors and/or filters.

∫ Temporarily Storing the Lens Hood

≥ The filter may become impossible to remove if

excessively tightened, so please refrain from

1 Turn the lens hood in the

tightening it too strongly.

≥ It is possible to attach the lens cap with the filter

direction of the arrow to

already attached.

detach it.

≥ You cannot attach a conversion lens or adaptor to

this lens. A filter may be used, but attaching any

other element may cause damage to the lens.

7

VQT4G75