Panasonic AW-IF400: Major operating controls and their functions

ENGLISH

Major operating controls and their functions

 Front panel

 Power LED [POWER]

 Extended Distance Transmission LED [EXTENSION]

This lights up green when DC power is supplied to the DC

This lights up when this unit is used to extend the

12 V input connector .

transmission distance between AW-RP400 and

AW-PH400.

 Transmission Status LED [COMMUNICATE]

This lights up when data is being transmitted between the

controller and pan/tilt head.

- 6 (E) -

Major operating controls and their functions

 Rear panel

 Controller connector [CONTROLLER]

 Pan/tilt head connector [PAN-TILT HEAD]

Use the controller CONTROL OUT TO PAN/TILT terminal

Use the pan/tilt head IP/RP terminal and a 10BASE-T

and a 10BASE-T (equivalent to UTP category 5) straight

(equivalent to UTP category 5) straight cable for

cable for connection.

connection.

- 7 (E) -

ENGLISH

Major operating controls and their functions

 Function Switches [SW1, SW2, SET UP]

 DC 12 V input connector [DC12V IN]

(Factory defaults: SW1 = OFF, SW2 = OFF,

Connect the AW-PS505A AC adapter (sold separately) to

SET UP No.1 = ON, SET UP No.2 to 4 = OFF)

this socket.

This is used to select the operations of the AW-IF400.

Before changing a setting, the power must be turned off.

SETUP No.3 is the tilt range selector switch which is used

to control the AW-PH400 from the AW-RP605A.

 Cable clamp

At the ON position, the range is 300 degrees; at the OFF

This is used to clamp the power cable in place and

position, it is 190 degrees. For any other combination, use

prevent it from coming loose.

the switch at the OFF position.

SET UP

SW1 SW2

Functions

No.1 No.2 No.3 No.4

MODE SET TILT RANGE NOT USE

ON

OFF

Controlling PH400 from RP605A OFF OFF ON OFF

OFF

(300 deg)

(190 deg)

Extending communication distance

OFF

ON ON OFF OFF

OFF

between RP400 and PH400

(Set at RP400)

Controlling PH350 from RP400 OFF ON OFF ON OFF OFF

- 8 (E) -