Vitek VT-1688 CAPELLA: ENGLISH

ENGLISH: Vitek VT-1688 CAPELLA

ENGLISH

Locking

To prevent use of the oven by children you can set the locking mode.

- Press and hold down the key “STOP/RESET “ during 3 sec, the audible signal occurs and the pictogram (4) lights

up.

- To release locking press and hold down the key “STOP/RESET” during 3 sec., the audible signal occurs and the

pictogram (4) goes out.

Special features

Auto reminder

- After the program for cooking or defrosting is finished, four audible signals occurs and an audible signals will

repeat every two minutes until the door of the oven is open or the key “STOP/RESET” is pressed.

- If setting of time or operating modes is not completely finished, the audible signal sounds in 30 seconds and

indications of the display are shown as initial ones.

Cooking during three stages

Your oven can be programmed by you for 3 subsequent stages of cooking.

Example: it is necessary to cook food within 35 minutes at the power of microwave equal to 80 %, then to switch

over to the mode of combined cooking for 20 minutes and to roast 15 minutes with grill.

1. Press the key “MICROWAVES” 2 times, the display shows the selected power as 80 %, the pictogram (7) and the

pictogram (9) - (1S - the first stage of cooking).

2. Turn the handle “TIME/AUTOMENU/WEIGHT” clockwise and set time as 35:00.

3. Press the key “GRILL/COMBINATION” 2 times, the pictograms (6, 7) and the pictogram (9) - (2S - the second

stage of cooking) light up.

4. Turn the handle “TIME/AUTOMENU/WEIGHT” clockwise and set time as 20:00.

5. Press the key “GRILL/COMBINATION”, the pictogram (6) and the pictogram (9) - (3S - the third stage of cooking)

light up on the display.

6. Turn the handle “TIME/AUTOMENU/WEIGHT” clockwise and set time as 15:00.

7. Press the handle “TIME/AUTOMENU/WEIGHT” to start cooking.

Depending on the stage of cooking in progress the pictogram (9) and a number of the stage lights up as well as

depending on the current cooking mode the pictograms (5), (6), (7) or (8) are blinking.

Note: During not programmed modes of cooking the pictogram (9) - 1S lights always.

Note: During all stages and modes of cooking the elements of display design corresponding to the pictogram 11

light up one after an other.

Stop of the oven during cooking

- To stop cooking just open the door of the oven. To continue cooking food, close the door and press the handle

“TIME/AUTOMENU/WEIGHT”.

- To cancel the cooking program press the key «STOP RESET».

Care and cleaning

Turn off the oven and disconnect from electrical power before cleaning.

Do not allow moisture to contact the control panel. Clean it with a soft, lightly dampened paper towel.

Keep the oven's cooking chamber clean. If pieces of food or liquid sprays are left on the chamber walls, remove

them with a damp paper towel.

A mild cleanser may be used if the chamber becomes exceptionally dirty.

Do not use abrasive cleaning instruments or wire brushes to clean the inside or outside of the oven. Make sure that

no water or cleanser gets in any of the ventilation or steam release openings on the top of the microwave oven.

Do not use ammonia-based cleansers.

The outer surfaces should be cleaned with a damp paper towel.

The oven door should always be clean. Do not allow crumbs of food to build-up between the door and the front

panel of the oven; this may prevent normal closure of the door.

Clean the ventilation openings on top of the oven housing regularly - keep them free of dust and dirt.

Regularly remove and wash the glass tray and its base - wipe the oven chamber floor clean.

Wash the glass tray and rotating drive mechanism in water with a neutral soap solution. These parts are dish-

washer safe.

Do not submerse the glass tray in cold water if it is still hot: the sudden drop in temperature can cause the glass

tray to break.

13

1688.indd 131688.indd 13 27.07.2006 17:11:4227.07.2006 17:11:42