Pioneer KRP-SW01W: Forward/Backward Angle of Inclination Adjustment Mechanism

14

En

Forward/Backward Angle of Inclination Adjustment Mechanism

On this stand, you can adjust the angle of inclination of the 

Pioneer display and television within a range of approximately 

2° forward or backward according to your preference.

 œÌi

• Be sure to adjust the angle only after you have 

attached the Pioneer display and television.

• Be sure to install it on a flat table or other flat 

surface.

• Be sure to hold the top of the Pioneer display 

and television with your hand while adjusting 

the angle.

Adjustment Procedure

1

  Loosen the forward/backward inclination 

anchor bolts using the enclosed hexagonal 

wrench (2 locations on the left and right).

While being sure to hold the top of the Pioneer display 

and television with your hand, loosen the 

forward/

backward inclination anchor bolts

 on the left and 

right sides by rotating them counterclockwise using the 

enclosed hexagonal wrench.

Forward/backward

inclination anchor bolt

Loosening

2

  Set the angle you prefer.

Set the angle you prefer by slowly moving the Pioneer 

display and television.

2° 2°

 œÌi

While adjusting the angle, be very careful to keep your 

hands out of the place indicated by the arrow on the  

figure.

3

  Tighten the forward/backward inclination 

anchor bolts (2 locations on the left and right).

Firmly tighten the 

forward/backward inclination 

anchor bolts

 on the left and right sides by rotating them 

clockwise using the enclosed hexagonal wrench. 

Be sure to hold the top of the Pioneer display and 

television with your hand until you have fully tightened 

the bolts.

Forward/backward

inclination anchor bolt

Tightening

4

  Check once more to make sure that the 

forward/backward inclination anchor bolts are 

fully tightened.