Pioneer S-81-K: инструкция

FRRD-232-A_S-81_En.book 1 ページ ２００８年７月２２日　火曜日　午後２時２６分

1

En

FRRD-232-A_S-81_En.book 2 ページ ２００８年７月２２日　火曜日　午後２時２６分

Thank you for buying this Pioneer product.

Please read through these operating instructions so you will know how to operate your model properly. After you have finished reading the

instructions, put them away in a safe place for future reference.

• Do not place magnetic objects such as screwdrivers or iron

parts near the tweeter or midrange. Since the speakers use

Before you start

strong magnets, the objects may be attracted, causing injury

• The nominal impedance of this speaker system is 6 Ω.

or damaging the diaphragm.

Connect the speaker system to an amplifier with a load

impedance ranging from 6 Ω to 16 Ω (a model with “6 Ω to

Cleaning the speaker cabinet

16 Ω” displayed on the speaker output terminals).

With normal use, wiping with a dry cloth should be sufficient to

In order to prevent damage to the speaker system resulting

keep the cabinet clean. If necessary, clean with a cloth dipped in

from input overload, please observe the following precautions:

a neutral cleanser diluted five or six times with water, and wrung

• Do not supply power to the speaker system in excess of the

out well. Do not use furniture wax or cleansers.

maximum permissible input.

Never use thinners, benzine, insecticide sprays or other chemicals

• When using a graphic equalizer to emphasize loud sounds

on or near this unit since these will corrode the surfaces.

in the high-frequency range, do not use excessive amplifier

volume.

Cleaning the glossy finish of the speaker system

• Do not try to force a low-powered amplifier to produce loud

S-81-K only

volumes of sound (the amplifier’s harmonic distortion will

be increased, and you may damage the speaker).

• If you use a dusty or hard cloth or if you rub the screen hard,

the finish of the product will be scratched.

Caution: installation

• If you clean the surface of the speaker system with a wet cloth,

• When placing this unit, ensure that it is firmly secured and

water droplets on the surface may enter into the product,

avoid areas where it may be likely to fall and cause injury in the

resulting in malfunction.

event of a natural disaster (such as an earthquake).

• When cleaning the finish of the speaker system, gently wipe it

• Do not attach these speakers to the wall or ceiling. They may

with a dry soft cloth; the supplied cleaning cloth.

fall off and cause injury.

• Do not install your speakers overhead on the ceiling or wall. If

improperly attached, the speaker grille can fall and cause

damage or personal injury.

What’s in the box

• Switch off and unplug your AV equipment and consult the

instructions when connecting up components. Make sure you

use the correct connecting cables.

Spike bases x 3

• The grille is affixed with magnets. The grille may fall if force is

applied to the grille in a horizontal direction. When cleaning

the speaker, remove the grille first.

Caution: in use

• Do not place the speaker on an unstable surface. It could

Metal catch x 1

present a hazard if it falls, as well as damaging the equipment.

• Do not use the speaker to output distorted sound for long

periods of times. This can result in a fire hazard.

Screw (for metal catch) x 1

• Do not sit or stand on the speaker, or let children play on the

Grille x 1

speaker.

Cleaning cloth (for S-81-K only) x 1

• Do not put large or heavy objects on top of the speaker.

Operating instructions

For U.S. model

WARNING:

Handling the cord on this product or

cords associated with accessories sold with the

product will expose you to chemicals listed on

proposition 65 known to the State of California and

other governmental entities to cause cancer and

birth defect or other reproductive harm.

Wash hands after handling

D36-P4_A_En

For European model

If you want to dispose this product, do not mix it with general household waste. There is a separate collection system for used

electronic products in accordance with legislation that requires proper treatment, recovery and recycling.

Private households in the member states of the EU, in Switzerland and Norway may return their used electronic products free of charge to

designated collection facilities or to a retailer (if you purchase a similar new one).

For countries not mentioned above, please contact your local authorities for the correct method of disposal.

By doing so you will ensure that your disposed product undergoes the necessary treatment, recovery and recycling and thus prevent potential

negative effects on the environment and human health.

K058_A_En

2

En

FRRD-232-A_S-81_En.book 3 ページ ２００８年７月２２日　火曜日　午後２時２６分

Using the spikes

This speaker system is supported by three points (the front two

How to install

legs, and the back spike located between the back two legs).

Tip-prevention legs

Choosing where to place the speaker systems

• Sounds played through speaker systems are easily affected in

Back

subtle ways by the conditions in the listening space.

English

• For best sound, choose a solid floor upon which to place the

speakers, and position the speakers as shown below. The level

Spikes

of low sounds can be adjusted by moving the speakers closer

Cabinet base

to or further from the wall. Adjust the speakers so that they are

equidistant from their respective side walls to assure balanced

sound.

Front

1 Set the spike bases in the positions where the points of

the three spikes will strike when the speaker is set down.

50 cm

20 cm

(19

11

/

(7

7

16

in.)

/

8

in.)

2 Set the speaker on the spike bases and check to confirm

the speaker does not rock.

50 to 60

• Always use the spike bases as shown, with the indented

surface facing up to receive the spike point.

• Place the left and right speakers equal distances from your

listening position for good stereo sound. Use speaker cords of

the same length for each speaker.

• So far as possible, place the front left and front right speakers

on the same plane as the TV screen.

• To achieve optimum surround sound, you should place the TV

between the left and right speakers, with the speakers

If you do not use the spike bases when placing the

pointing at a 50 to 60 degree angle toward the listening

speakers, the spikes may cause damage to the floor. If

position.

you plan on using the spikes we highly recommend to

• If the room has a lot of reverberation, we recommend hanging

use the spike bases.

heavy fabric on the walls, and/or putting a carpet on the floor

to damp the sound. For best results, cover walls completely.

Mounting the Fall-Prevention Fastener

• Using the included screw, tightly secure the metal catch to the

backside of the speaker.

• Pioneer assumes no liability whatsoever for damages

resulting from assembly, improper mounting, insufficient

reinforcement, misuse of the product, acts of nature, etc.

S-81-QL only

• Pass a commercially-available reinforced string through the

• The cabinet uses sliced veneer made of natural wood. Do not

metal catch to securely support the speaker to the wall. Be

place the speaker where it will be in direct sunlight, and avoid

sure that the wall to which you fasten the speaker is strong

positioning it near heaters and air conditioners. Doing so may

enough to support the weight of the speaker. After fastening

cause warping and discoloration of the speaker cabinet and

the speaker, make sure that it does not fall over.

damage to the speaker.

• The speaker can incur damage in the event of a fall.

• Do not attach the metal catch directly to the wall. It should

only be used in conjunction with reinforced string to prevent

the speaker from falling.

Metal catch

Reinforced strings

Backside of speaker

• Pass two reinforced strings through the metal catch, and

fasten the speaker to the wall as shown above.

3

En