Vitek VT-1668: ENGLISH

ENGLISH : Vitek VT-1668

ENGLISH

3. Stage 2 cooking process pictogram.

4. Colon.

5. Set start time mode pictogram.

6. "LOCK"  Child lock mode pictogram.

7. "Jet defrost" mode pictogram.

8. "Grill" cooking mode pictogram.

9. Combination cooking mode 1 pictogram.

10. Combination cooking mode 2 pictogram.

11. Oven "ON" pictogram.

Assembling the microwave oven

Remove the packing material and accessories from the cooking chamber of the oven. Inspect the microwave oven

for any deformities. Pay special attention to the operation of the oven door. If any defects are found, do not install

the oven and do no turn it on.

Protective covering

Housing: Remove the protective film (if any) from the microwave housing.

Do not remove the lightgrey micaceous plate from the inside of the cooking chamber; it protects the magnetron.

Installing the glass tray

1. Install the base for the rotating tray (4) into the opening located in the floor of the cooking chamber.

2. Install the rolling ring (5) onto the floor of the cooking chamber.

3. Carefully install the glass tray (6), aligning its lip with the grooves on the base. Never install the glass tray upside

down.

Do not block the rotation of the glass tray during the cooking process.

During the cooking process, always use the glass tray, rolling ring and tray base.

Food and cooking dishes must always be placed only on the glass tray.

The glass tray may rotate clockwise or counterclockwise. This is normal.

Replace the tray immediately if it becomes cracked or chipped.

Installation

Before connecting the microwave oven, make sure that the operating voltage and power usage matches the

parameters of your electrical system. Connect the microwave oven to a grounded electrical outlet.

Install the oven on a flat, stable surface. Choose a location that will not be accessible to small children.

Install the oven so that the distance between the wall and the back of the oven is no less than 78 cm and the free

space above the microwave is no less than 30 cm.

Do not remove the legs from the bottom of the microwave oven.

Do not block the ventilation openings on the microwave oven's housing.

The microwave oven should be installed away from televisions and radios in order to prevent static interference of

radio and television signals.

WARNING: Do not install the microwave oven on heating surfaces (kitchen stoves) or other sources of heat waves.

If the microwave oven malfunctions due to user error, the warranty for free service and repair is voided.

While operating, the top surface of the microwave oven and heat up significantly; avoid touching hot surfaces of the

oven with bare skin in order to prevent burns.

Using the oven

Audible signal

Each time a button on the control panel is pressed the oven will emit an audible "beep."

Setting the current time

Let's say you want to set the current time as "6:00" (AM or PM):

1. Insert the power plug into the outlet.

2. Press "Clock."

3. Press "Cancel."

4. Press the "1 Min" button 6 times to set the hour.

5. Press "Clock" to confirm the set time; the colon (4) on the display will start to blink.

Note: this model uses a 12hour clock. Press the "Clock" button during the cooking process to see the current time

on the display.

7

Vt-1668.qxd 21.06.05 16:50 Page 7