AEG MC 4443: English

36

English

10 TUNING control

• Removetheprotectivelmfromthedisplayifitisstill

11 USB connection

present.

12 BAND Band selection switch (AM / FM / FM ST.)

13 SKIP+ button (reverse search)

Power Supply

14

SKIP- button (forward search)

• Inserttheplugintoaproperlyinstalled230V,50Hz

15 MODE button (repeat/random)

power socket.

16 IR Sensor for the remote control

• Pleaseensurethatthemainsvoltagecorrespondstothe

17 FM ST. control lamp

information on the type plate.

18 POWER control lamp

Setting the Time (in standby mode (OFF))

Reverse Side

• Performthesettingswiththebuttons

SKIP+/ SKIP-

19 SPEAKERS R/L Loudspeaker connections

(13/14/3).

20 Battery compartment (Power reserve)

• Conrmyourentrieswiththe PLAY/PAUSE/USB but-

21 AC Mains connection

ton (6/1).

22 FM ANT. throw-out aerial

1. Keep the

PLAY/PAUSE/USB button (6/1) pressed

down. The notification “24 H” appears in the display.

Remote Control

2. You may now successively perform the settings for the

1

button (Play/Pause)

display format (24 H or 12 H), the hours and the minutes.

2 PROG button (memory)

NOTE:

3 / buttons (reverse search/forward search)

4 ALBUM button (up album)

In the 12-hour notification, the following will appear in the

5 +10 button

display:

6 MODE button (repeat/random)

AM = in the morning; PM = in the afternoon/evening

7 STOP button

NOTE:

Storage/display of the time is lost as soon as the electric-

Intended Use

ity supply is interrupted. If you would like to have the time

displayed even when the power is disconnected, insert a

This device is used for:

button cell of type CR 2025 with the correct polarity in the

• Thereceptionofradioprogrammes

battery compartment (20) (battery not supplied). Open the

• Playingbackaudio/MP3CDs

lid of the battery compartment on the back by turning in

• Soundplaybackfromexternalaudiosources.

the direction of

OPEN.

Itisintendedexclusivelyforthispurposeandmayonlybe

used as such.

Inserting the Batteries

It may only be used in the manner described in these instruc-

NOTE:

tions for use. The device must not be used for commercial

The lithium cell in the battery compartment of the remote

purposes.

control has been secured for transport with a foil. This

Any other use of this device is considered to be contrary to

prolongs the lifetime of the battery. Before initial use please

the intended use and may result in damage to materials or

remove this foil so that the remote control is ready for

even personal injury.

operation.

The firm ETV – Elektro-Technische Vertriebsgesellschaft mbH

The battery of the remote control is a long-life lithium cell. If

does not accept any liability for damage caused as a result of

the range of the remote control is reduced during use, please

the use of this device contrary to its intended use.

proceed as follows:

• Openthebatterycompartmentonthebackofthe

Start-up of the device/Introduction

remote control.

• Replacethecellbyabatteryofthesametype(CR2025).

• Readtheoperatinginstructionsthoroughlybeforethe

Ensure correct polarity.

start-up!

• Thenclosethebatterylid.

• Selectanappropriatelocationforthedevice,e.g.adry,

at,non-slipsurfaceonwhichthedevicecanbeeasily

If the remote control is not used for a prolonged period,

operated.

remove the batteries in order to prevent battery acid leaking.

• Makesurethatthedeviceisadequatelyventilated!

CAUTION:

• Connecttheloudspeakerstothebackofthemusic

Batteries are not to be disposed of together with domestic

centre to the sockets market “Speaker R and L” (19).

wastes. Dispose of the used batteries at the relevant collec-

tion bin or at your dealer’s.