Vitek VT-2342: ENGLISH

ENGLISH

pull it towards yourself (Picture 2). Remove

1. Filter is dirty. 1. Replace filter.

the lid (Picture 3). Take filters’ block out by

2. Apply to the

pulling the strips (Picture 4). Insert new fil-

High noise

authorized

2. Appliance

level

service center

ters’ block into the purifier: first insert its

malfunction.

for the appli-

upper part, afterwards it lower part. Close

ance repair.

the lid uniting the slots in purifier housing

with lugs on the lid.

Technical Specifications

Supply voltage: AC 220-240V, ~ 50 Hz

Replacing UV-lamp

Power supply: 110 W

Make sure the appliance is disconnected

Noise level: 65 dB

from the wall outlet before replacing UV-

2

Room capacity: 60 m

lamp.

Weight: 7.2 kg

Take lower corners of the air inlets lid and

Dimensions: 470*228*445 (mm)

pull it towards yourself (Picture 2). Remove

Negative ions output: (at distance of 10 cm

the lid (Picture 3). Take filters’ block out by

3

from air outlet) 200mln/cm

pulling the strips (Picture 4).

Carbonic acid absorption: (ppm – parts per

Turn off the screws fastening the screen of

million) 95%

the lamp by screwdriver, remove the screen.

Operating conditions: environment tem-

Carefully rotate the lamp for quarter of turn

perature -40 to +40°С

in any direction, take the lamp out. Insert

Relative humidity of the air less than 90%

new UV-lamp and rotate the lamp for quar-

ter of turn in any direction. Install the screen

Specifications subject to change without

of the lamp into its position. Install filters’

prior notice.

block. Close the lid of the purifier.

MINIMUM SERVICE LIFE - 5 YEARS

Trouble Shooting

Possible

GUARANTEE

Malfunction

Elimination

causes

Details regarding guarantee conditions can

1. Appliance is

1. Insert the

be obtained from the dealer from whom

not plugged

plug into the

the appliance was purchased. The bill of

in the socket.

wall outlet.

2. In order to

sale or receipt must be produced when

test the sock-

making any claim under the terms of this

2. There is no

et try to plug

guarantee.

power in the

any other

wall outlet or

electric ap-

supply line.

This product conforms to the

pliance in the

Appliance

EMC-Requirements as laid

same socket.

cannot be

down by the Council Directive

3. Front lid of

3. Check out

switched on

89/336/EEC and to the Law

filters’ block

if front lid of

are not in-

filters’ block

Voltage Regulation (73/23 EEC)

stalled prop-

are installed

erly.

properly.

4. Apply to the

authorized

4. Appliance

service center

malfunction.

for the appli-

ance repair.

7

2342.indd 72342.indd 7 02.08.2007 12:06:3702.08.2007 12:06:37