AEG sr4362: English
English: AEG sr4362
English
31
2. Insert 6 batteries of type UM2/R14 1.5 V. Please ensure
Overview of the Components
that the polarity is correct (see the floor of the battery
1 Telescopic antenna
compartment)!
2 CD compartment
3. Then close the battery lid.
3 TUNING control
NOTE:
4 OPEN/CLOSE – Tab for opening the CD compartment
When a mains cable is connected the batteries are auto-
5 POWER control lamp
matically switched off.
6 PLAY/PAUSE button
7 ALBUM button
CAUTION:
8 / buttons
• Batteries can leak battery acid. If the device is out of
9 USB port
use for a long period of time, remove the batteries.
10 MODE button
• Different battery types or new and used batteries must
11 STOP button
not be used together.
12 Display
• Batteries are not to be disposed of together with
13 VOLUME control
domestic wastes. Dispose of the used batteries at the
14 Function switch (CD/USB/AUX IN / OFF / RADIO)
relevant collection bin or at your dealer’s.
Reverse (not shown)
WARNING:
AC Mains connection
The batteries shall not be exposed to excessive heat such
AUX-IN input
as sunshine, fire or the like. Danger of explosion!
Underside (not shown)
Transport Safety Device, CD Compartment
Battery compartment
• Open the CD compartment (2) by pulling the lid upwards
by the tab (4).
Start-up of the device/introduction
• Before operating the machine for the rst time, remove
the transport safety device from the CD player if it is still
• Select a suitable location for the device, such as a dry,
in place.
flat, non-slip surface on which it is easy to operate the
machine.
Volume
• Ensure that the device is sufciently ventilated!
You can adjust the desired volume with the VOLUME control
• Remove the protective lm from the display if it is still
(13).
present.
Turning the device off
Power Supply
The device turns off when you set the function switch (14) to
• Ensure that the voltage is the same as that indicated on
the “OFF” position. The POWER control lamp (5) turns off.
the model identification plate.
Then disconnect the mains plug.
• Connect the power cable supplied (see battery compart-
ment if necessary) to a properly installed safety power
socket and the mains connector AC on the back of the
Listening to the Radio
machine.
1. Set the function switch (14) to the “RADIO” position.
NOTE: In CD/USB/AUX IN mode
2. Completely extend the telescopic antenna. Change its
The device integrates an auto-off function for the purpose
position to improve the reception.
of saving energy. When in stop mode, for example when
3. Tune the desired station with the TUNING control (3).
CD playback has been finished, the device turns off auto-
matically after 10 minutes. Proceed as follows to turn the
Playing CDs/MP3
device on again:
1. Set the function switch (14) to “OFF” position first.
NOTE:
2. Then set the function switch back to the desired oper-
If an audio cable is connected to the AUX IN socket, the
ating mode.
device cannot be operated in CD/MP3 mode.
1. Set the function switch (14) to the “CD/USB/AUX IN”
Inserting the Batteries (not supplied)
position.
1. Open the lid of the battery compartment on the bottom.
2. Open the CD compartment (2) by pulling the lid upwards
by the tab (4).
Оглавление
- Inhalt
- Übersicht der Bedienelemente
- Deutsch
- Deutsch
- Deutsch
- Deutsch
- Deutsch
- Deutsch
- Nederlands
- Nederlands
- Nederlands
- Nederlands
- Nederlands
- Français
- Français
- Français
- Français
- Français
- Español
- Español
- Español
- Español
- Español
- Italiano
- Italiano
- Italiano
- Italiano
- Italiano
- English
- English
- English
- English
- English
- Język polski
- Język polski
- Język polski
- Język polski
- Język polski
- Język polski
- Magyarul
- Magyarul
- Magyarul
- Magyarul
- Magyarul
- Українська
- Українська
- Українська
- Українська
- Українська
- Русский
- Русский
- Русский
- Русский
- Русский