Vitek VT-4203 SR: E N G L I S H

7

– Do not place the multi-cooker close to the

Note: Make sure that the level of products and

objects that can be damaged by the hot

liquids doesn’t exceed the maximal mark « 10»

released steam.

and doesn’t lie below the minimal mark «2».

Attention! Do not use the unit near bath tubs,

– Install the bowl (12) into the process cham-

kitchen sinks or other containers filled with

ber. Make sure that the bowl (12) is placed

water.

evenly and has a tight contact with the heat-

– Remove the steam release lid (6) pulling it

ing element surface (10).

upwards.

Note:

– Open the multi-cooker lid (5) by pressing the

• Do not use the bowl (12) for washing cereals

button (4).

and chopping products, as this can damage

– Remove the protection screen (13) with the

the non-stick coating;

silicone gasket by pressing the clamps (14).

• Make sure that there are no foreign objects,

– Wash all the removable parts: protection

dirt and moisture in the process chamber and

screen (13) with the silicone gasket, steam

on the bottom of the bowl (12);

release lid (6), bowl (12), steam cooking bas-

• Wipe the outer surface and the bottom of the

ket (15), soup ladle (16), spatula (17) and

bowl (12) dry before use;

measuring cup (18) with a soft sponge and

• In the middle of the heating element (10)

neutral detergent, then rinse under running

there is a temperature sensor (11); make

water and dry.

sure that the movement of the sensor is not

– Clean the unit body with a damp cloth, then

limited;

wipe it dry.

• If you steam food, pour water in the bowl (12)

– Install the protection screen (13) with the sili-

so that boiling water doesn’t reach the bot-

cone gasket back to its place.

tom of the tray (15). Put the tray with food (15)

– Install steam release lid (6) back to its place.

into the bowl (12);

• After steam cooking do not remove the food

Current time setting

with bare hands, use kitchen tools.

– Insert the power cord connector into the

• Close the lid (5) until click.

socket (9).

• Insert the power cord connector into the

– Insert the power plug into the mains socket,

socket (9); insert the power plug into the

there will be a sound signal and the operation

mains socket.

indicator (24) will blink.

– Press and hold the «Hours» (21) or «Minutes»

Auto-cooking programs

(31) button for about 3 seconds, there will be

– To select auto-cooking program set the indi-

a short sound signal, and digital time indica-

cator «» against the required program (28)

tions on the display (2) will start blinking.

by pressing the «MENU» button (26) repeat-

– Set the current time (24 Hr) by consequent

edly.

pressing or holding the «HOURS» (21) and

– In the «RICE» mode you can select the readi-

«MINUTES» (31) buttons.

ness degree of rice by consequent pressing

– Press the «START/STOP» button (25) to finish

of the «TASTE» button (23), the selected set-

setting time.

tings will be shown as symbols (29) on the

– The current time will appear on the display (2)

display (2):

and dots «:» will start blinking.

«SOFT» – glutinous rice, porridge;

Note: If no actions for current time setting are

«MODERATE» - tough rice, but not raw in the

taken and the «START/STOP» button (25) is not

middle (al dente);

pressed within 1 minute, the display indications

«HARD» – tough rice for garnish.

will remain unchanged.

– When selecting programs with cooking time

setting option («STEAM COOKING», «STEW»,

USING OF THE MULTI-COOKER

«SOUP» and «BROTH») the symbol (22)

– Put the food into the cooking bowl following

«COOKING TIME» will appear on the display

the recommendations given in the recipes

(2). Press the “TIME” button (27) to set the

(see “Recipe book”).

VT-4203.indd 7 07.12.2012 14:06:56