Vitek VT-1228: ENGLISH
ENGLISH: Vitek VT-1228
ENGLISH
in order quickly during travelling or busi-
• Do not fill the water tank with scent-
ness trips, but it does not replace the usual
ed liquids, vinegar, starch solution,
household iron.
descaling reagents, chemical agents
etc.
IRONING WITHOUT AN IRONING BOARD
• After you finish ironing, switch off the
During travelling, an ironing board is not al-
unit, wait until it cools down completely
ways at hand, for such cases it is enough to
and then open the water tank lid (3) and
lay twofold terry towel on the flat surface. Pre-
drain the remaining water.
liminary make sure, that the surface is heat
resistant and waterproof. Do not use glass or
IRONING TEMPERATURE
plastic surfaces.
Before operating, test the heated iron on the
cloth to be sure that the iron sole (9) and the
BEFORE FIRST USAGE
water tank (4) are clean.
• Unpack the iron; remove the protective
• Always check the recommended iron tem-
cardboard covering (if any) from the iron
perature indicated on the tag before iron-
sole (9).
ing.
• Wipe the iron sole with a dry cloth.
• If the tag does not list the recommended
• Before connecting the iron to the electric
ironing temperature, but you know the type
network set the power supply switch (8)
of fabric, then use the following table to de-
in correspondence with the voltage of the
termine the proper temperature.
electric network. After usage of the iron with
network voltage 110 V always set the switch
Marks Fabric type (temperature)
(8) to the 220 V position, it will prevent mal-
Synthetics, nylon, acryl, polyester (low
•
function of the iron while connecting the iron
temperature)
•• Silk/wool (medium temperature)
to the electric network with the increased
•••
voltage.
Cotton/linen (high temperature)
(max)
FILLING THE WATER TANK
• This table is only for smooth materials. Fab-
Before filling the water tank with water, make
rics of other types (crimped, raised etc.) are
sure that the iron is unplugged.
best ironed at low temperature.
• Lift the handle (1) and it will lock, to lower
• First sort items by ironing temperature: syn-
the handle (1) press the (7) button and low-
thetic materials to synthetic materials, wool
er the handle.
with wool, cotton with cotton etc.
• Set the temperature control (11) to the “min”
• The iron heats up faster than is cools down.
position and the constant steam supply han-
For this reason it is recommended to begin
dle (12) to the “
” position (steam supply is
ironing at low temperature (for instance
off).
synthetic fabrics).
• Open the water tank lid (3).
• After that, move to higher temperature iron-
• Do not pull the lid strongly, slight effort is
ing. Cotton and linens should be ironed
enough.
last.
• Fill the water tank with water, using the
• If an item is made of a mix of fabrics, then
measuring jug (13); firmly close the lid
the iron should be set for the fabric with
(3).
the lowest ironing (for instance if an item is
made of polyester and cotton, it should be
Note:
ironed at the temperature used for ironing
Steam will not be supplied if there is no
polyester “•”).
water in the water tank.
• If you cannot define the fabric the item is
• If you need to refill the water tank during
made of, find a place on it that is hidden
ironing, switch off the iron and remove
while wearing and, on practice select the
the power plug from the outlet.
ironing temperature (always start at the low-
4
1228.indd 41228.indd 4 29.03.2011 12:57:2129.03.2011 12:57:21
Оглавление
- ENGLISH
- ENGLISH
- ENGLISH
- ENGLISH
- DEUTSCH
- DEUTSCH
- DEUTSCH
- DEUTSCH
- РУССКИЙ
- РУССКИЙ
- РУССКИЙ
- РУССКИЙ
- ҚАЗАҚ
- ҚАЗАҚ
- ҚАЗАҚ
- ҚАЗАҚ
- ROMÂNĂ/ MOLDOVENEASCĂ
- ROMÂNĂ/ MOLDOVENEASCĂ
- ROMÂNĂ/ MOLDOVENEASCĂ
- ROMÂNĂ/ MOLDOVENEASCĂ
- ČESKÝ
- ČESKÝ
- ČESKÝ
- ČESKÝ
- УКРАЇНСЬК А
- УКРАЇНСЬКА
- УКРАЇНСЬК А
- УКРАЇНСЬКА
- БЕЛАРУСКI
- БЕЛАРУСКI
- БЕЛАРУСКI
- БЕЛАРУСКI
- ЎЗБЕК
- ЎЗБЕК
- ЎЗБЕК
- ЎЗБЕК