Pioneer PDK-TS36B: Forward/Backward Angle of Inclination Adjustment Mechanism
Forward/Backward Angle of Inclination Adjustment Mechanism: Pioneer PDK-TS36B
Forward/Backward Angle of Inclination Adjustment Mechanism
On this stand, you can adjust the angle of inclination of the
Pioneer television within a range of approximately 2° forward
or backward according to your preference.
6
En
• Be sure to adjust the angle only after you have
attached the Pioneer television.
• Be sure to install it on a flat table or other flat
surface.
• Be sure to hold the top of the Pioneer television
with your hand while adjusting the angle.
Adjustment Procedure
1
Loosen the forward/backward inclination
anchor bolts using the enclosed C wrench (2
locations on the left and right).
While being sure to hold the top of the Pioneer television
with your hand, loosen the
forward/backward
i
nclination anchor bolts
on the left and right sides by
rotating them upwards using the enclosed C wrench.
2
Set the angle you prefer.
Set the angle you prefer by slowly moving the Pioneer
television.
3
Tighten the forward/backward inclination
anchor bolts (2 locations on the left and
right).
Firmly tighten the
forward/backward inclination
anchor bolts
on the left and right sides by rotating them
downward using the enclosed C wrench.
B
e sure to hold the top of the Pioneer television with your
hand until you have fully tightened the bolts.
While adjusting the angle, be very careful to keep your
hands out of the place indicated by the arrow on the
figure.
4
Check once more to make sure that the
forward/backward inclination anchor bolts
are fully tightened.
Оглавление
- Cautions
- Checking the Enclosed Parts
- Assembling the Stand
- Attaching the Pioneer Television
- Forward/Backward Angle of Inclination Adjustment Mechanism
- Installing the Product on a TV table etc.
- Preparing the Cables
- Preventing Equipment from Falling Over
- Fixing the rotation to the front
- Dimensions Diagram
- Avertissements
- Vérification des pièces contenues dans le carton d’emballage
- Assemblage du pied de table
- Installation et fixation du téléviseur Pioneer
- Mécanisme d’ajustement de l’angle d’inclinaison en avant et en arrière
- Installation du produit sur un meuble de télévision, etc.
- Préparation des câbles
- Prévenir le basculement et la chute de l’équipement
- Fixation de la rotation à l’avant
- Schéma de dimensions
- Sicherheitshinweise
- Überprüfen der mitgelieferten Teile
- Montage des Ständers
- Montage des Pioneer-Fernsehers
- Justiermechanismus für den Neigungswinkel nach vorn und nach hinten
- Installieren des Produkts auf einem Fernsehtisch oder etwas Ähnlichem
- Verlegen der Kabel
- Mittel zur Verhütung des Umstürzens
- Fixierung der Drehung an der Vorderseite
- Abbildungen zu den Abmessungen
- Precauzioni
- Verifica dei Pezzi Contenuti nella Confezione
- Montaggio del Supporto
- Fissaggio del televisore Pioneer
- Meccanismo di Regolazione dell’Inclinazione dell’Angolo in Avanti/Indietro
- Montaggio del prodotto in un mobiletto porta TV, ecc
- Preparazione dei cavi
- Prendere precauzioni contro la caduta dell’apparecchio
- Fissare la rotazione verso la parte anteriore
- Diagramma delle Dimensioni
- Waarschuwingen
- Controleer de meegeleverde onderdelen
- Monteren van de Staander
- Bevestiging van de Pioneer Televisie
- Instellingsmechanisme voor de voor- en achterwaartse hellingshoek
- Installatie van het product op een TV-tafel enz.
- Voorbereiding van de kabels
- Zorg ervoor dat het apparaat niet omvalt
- Vastzetten van de draaiing voorwaarts
- Schema van afmetingen
- Precauciones
- Comprobación de las piezas incluidas
- Montaje del soporte
- Cómo montar el televisor Pioneer
- Mecanismo de ajuste del ángulo de inclinación delantera y posterior
- Instalación del producto en una mesa de TV u otro lugar similar
- Preparación de los cables
- Cómo evitar que el equipo se caiga
- Cómo fijar la rotación en la parte delantera
- Diagrama de dimensiones
- 注 意
- 核對隨附零件
- 組合支架
- 安裝先鋒電視
- 前後角度傾斜調整的機械裝置
- 將產品安裝至電視桌等部位上
- 線路準備
- 預防設備翻覆
- 固定前方的旋轉
- 尺寸圖
- Содержание
- Проверка входящих в комплект деталей
- Сборка столика-подставки
- Подсоединение телевизора Pioneer
- Механизм регулировки угла наклона вперед/назад
- Установка продукта на тумбе под телевизор и т.д.
- Подготовка кабелей
- Предотвращение падения оборудования
- Предотвращение от наклона вперед
- Размеры