Pioneer mvh-170ub: Before You Start Getting Started

Before You Start

Getting Started

Thank you for purchasing this PIONEER product

To ensure proper use, please read through this manual before using this product. It is especially

Basic operation

important that you read and observe WARNINGs and CAUTIONs in this manual. Please keep the

manual in a safe and accessible place for future reference.

English

MVH-X370BT/170UI/170UBG/170UB

If you want to dispose this product, do not mix it with general household waste. There is a separate

collection system for used electronic products in accordance with legislation that requires proper

treatment, recovery and recycling.

Private households in the member states of the EU, in Switzerland and Norway may return their used

electronic products free of charge to designated collection facilities or to a retailer (if you purchase a

similar new one).

For countries not mentioned above, please contact your local authorities for the correct method of

disposal.

By doing so you will ensure that your disposed product undergoes the necessary treatment, recovery

and recycling and thus prevent potential negative effects on the environment and human health.

*1 The button indications vary depending on the unit.

*2 This button is referred to as DISP in this manual.

WARNING

•Do not attempt to install or service this product by yourself. Installation or servicing of this

product by persons without training and experience in electronic equipment and automotive

Frequently used operations

accessories may be dangerous and could expose you to the risk of electric shock, injury or other

The available buttons vary depending on the unit.

hazards.

•Do not attempt to operate the unit while driving. Make sure to pull off the road and park your vehicle

Purpose Operation

in a safe location before attempting to use the controls on the device.

Turn on the power* Press SRC/OFF to turn on the power.

CAUTION

Press and hold SRC/OFF to turn off the

power.

•Do not allow this unit to come into contact with moisture and/or liquids. Electrical shock could result.

Also, damage to this unit, smoke, and overheating could result from contact with liquids.

Adjust the volume Turn the M.C. dial.

•Always keep the volume low enough to hear outside sounds.

Select a source Press SRC/OFF repeatedly.

•The Pioneer CarStereo-Pass is for use only in Germany.

Change the display information Press DISP repeatedly.

If you experience problems

Return to the previous display/list Press /DIMMER.

Should this unit fail to work properly, please contact your dealer or nearest authorized PIONEER Service

Return to the normal display from the

Press BAND/.

Station.

menu.

Answering/ending a call (Only for MVH-

Press .

X370BT)

3En

* When this unit’s blue/white lead is connected to the vehicle’s auto-antenna relay control terminal,

Important

the vehicle’s antenna extends when this unit’s source is turned on. To retract the antenna, turn the

• Avoid subjecting the front panel to excessive shock.

source off.

• Keep the front panel out of direct sunlight and high temperatures.

• Always store the detached front panel in a protective case or bag.

Display indication

Indication Description

Appears when a lower tier of the menu or folder exists.

When you turn the ignition switch to ON after installation, [SET UP :YES] appears in the

display.

Appears when the automatic answering function is set (page 10).

(Only for Bluetooth-compatible models.)

1 Press the M.C. dial.

Appears when the button is pressed.

The setup menu disappears after 30 seconds of no operation. If you prefer not to set

at this time, turn the M.C. dial to select [NO], then press to confirm.

Appears when the local seek tuning function is set (page 11).

Appears when a traffic program is received.

2 Turn the M.C. dial to select the options, then press to confirm.

To proceed to the next menu option, you need to confirm your selection.

Appears when traffic announcements are received (page 11).

Appears when the sound retriever function is set (page 12).

Appears when random/shuffle play is set (except when BT AUDIO is

selected as the source).

Appears when repeat play is set (except when BT AUDIO is selected as the

source).

Appears when the iPod control function is set (page 7).

Appears when a Bluetooth connection is made (page 8).

(Only for Bluetooth-compatible models.)

3 [QUIT :YES] appears when all the settings have been made.

Detaching the front panel

To return to the first item of the setup menu, turn the M.C. dial to select [QUIT :NO],

Detach the front panel to prevent theft. Remove any cables and devices attached to the

then press to confirm.

front panel and turn off the unit before detaching it.

4 Press the M.C. dial to confirm the settings.

NOTES

• You can cancel the menu setting by pressing SRC/OFF.

• These settings can be made at any time from the SYSTEM settings (page 13) and INITIAL settings

(page 5).

4En

Setup menu

Menu Item Description

LANGUAGE Select the language to display the text information from a

compressed audio file.

[ENG](English),

[РУС](Russian),

[TUR](Turkish)

CLOCK SET Set the clock.

FM STEP Select the FM tuning step from 100 kHz or 50 kHz.

[100], [50]