AEG sr4353: English

36

English

Amplifying bass

Playing CDs/MP3

Press the BASS switch (23) to turn the bass amplification on or

off.

This is how you play a CD

1. Turn the function selector switch (26) to the “CD/MP3/

Switch-off

AUX”.

he machine is switched off when the function selector switch

2. Open the CD tray (2) by pressing the PUSH TO OPEN

(26) is turned to the TAPE OFF position. The POWER (24)

button (7).

control lamp goes off. Unplug the device.

3. Insert an audio CD with the printed side facing upwards

on to the central cone so that the CD clicks into place

NOTE:

and then close the lid of the CD compartment.

After approx. 15 minutes without a signal, the device will

4. After a few seconds the total number of songs/tracks is

automatically switch to standby. To use the device again,

shown in the display.

press the / button (10).

NOTE:

In the case of CDs in MP3 format the number of folders

AUX IN jack

is briefly displayed at first.

1. Connect the 3.5 mm stereo RCA cable to an external

5. Press the

/ button (10) to restart playback. The CD

audio source. If required, use a suitable adapter (not

will play from the first title. The current track and the “CD

included).

“ or “MP3 “ message are shown on the display.

2. Insert the other end of the cable into the AUX-IN jack

(Back Side) on the unit.

NOTE:

3. Set the function selector switch (26) to the “CD/MP3/

With CDs in MP3 format the current track and folder

AUX” position.

are shown alternately in the display.

4. Start the playback of your audio source. Listen to the

6. In order to remove a CD, please press the

button (11),

sound playback via the speaker.

open the CD compartment and lift the CD out carefully.

5. For the further procedure, please refer to the user manual

of the external audio source.

Always keep the CD deck closed.

NOTE:

NOTE:

If possible, adjust the volume of the external unit to a com-

• If a disc is inserted the wrong way, or if no disc is

fortable level.

inserted, the message “– – –” will flash and “NOd” will

appear on the display.

• Playback of CDs produced by the user cannot be

Listening to the Radio

guaranteed due to the large variety of software and CD

media available.

1. Set the function selector switch (26) to the “RADIO” posi-

tion.

2. Select the desired frequency band with the band selector

Description of the CD buttons

switch (3).

/ (10)

VHF (Stereo) = FM.ST, Medium wave = AM (Mono)

You can briefly interrupt and resume playback using this but-

2. Tune in the desired station with the station adjustment

ton. The symbol “

“ flashes on the display. Pressing again

knob TUNING (5).

continues playback.

3. The FM ST. indicator lamp (19) will only be lit, when the

station is received in stereo quality. If reception is too

/ (9/8)

weak and there is noise on the station being received,

When playing an audio CD or a CD in MP3 format:

this lamp will flicker.

With you can jump to the next or previous track etc.

4. For FM mode pull out the telescopic antenna (6) and turn

• If the button is kept pressed down, the machine starts to

it to improve reception.

search through the tracks.

5. An aerial is integrated into the device for the reception of

AM stations. The machine can be aligned to the station

The button can be used as follows:

by turning it. In this frequency band programs are trans-

Press once = This jumps back to the previous track.

mitted in “mono” only.

Press twice = This plays the song before etc. If the button

is kept pressed down, the machine starts to

search through the tracks.