Vitek VT-1814: ENGLISH

ENGLISH: Vitek VT-1814

Vt-1814.qxd 10.02.05 10:32 Page 6

ENGLISH

To remove the Hose, press the clamps and pull.

Cleaning the Inlet Filter

Inlet Filter should be cleaned at least twice a

2. Fitting the Extension Tubes and Brushes

year (or whenever necessary).

a. Fit the extension tube to the hose handle.

Inlet Filter protects the motor from dust and

b. Select the required Floor/Carpet Brush (1)

litter in case the Paper Dust Bag breaks

or Universal Flat Brush (12) and fit it onto the

open. Never operate your vacuum cleaner

telescopic Tube.

without the Inlet Filter.

USING THE BRUSHES

1. Switch the vacuum cleaner off and unplug.

Universal Flat Brush stored in the holder on

2. Remove the Dust Bag.

backside of the unit is suitable for:

3. Remove the Inlet Filter.

cleaning of radiators, crevices, corners and

4. Wash the Inlet Filter in warm water and allow

spaces between the cushions;

to dry.

cleaning of furniture, curtains, books, floor

Never use dishwashing machine to clean

lamps, shelves and dusting of the house-

the Inlet Filter

plants.

Never use the hair dryer to dry the filter

5. Replace the Inlet Filter, the Dust Bag and

Floor/Carpet Brush

close the cover.

Set the switch on the brush into required posi-

tion depending on the type of surface to be

Replacing the Outlet Filter

cleaned.

1. Open Outlet Filter Cover (13).

2. Remove the filter and replace it.

INSTRUCTION MANUAL

3. Close Outlet Filter Cover (13) back in place.

Before using the appliance, unwind a sufficient

length of cable and insert the plug into the

Housing

power socket. Yellow mark on the power cable

Wipe the housing with damp cloth.

shows the ideal cable length. Do not extend the

Make sure no water or liquids occur inside

cable beyond the red mark.

the housing.

Never use solvents and abrasive agents to

1. Press Power On/Off Button (5) to switch the

clean the housing of your vacuum cleaner.

vacuum cleaner on.

2. Press Rewind Button (8) to rewind the

SPECIFICATIONS

power cable.

Power requirement: 220/230 V ~ 50 Hz

Guide the cable with the other hand to pre-

Max. power: 1600 W

vent whipping and damaging.

Suction Power: 310 W

3. Use the Power Regulator (6) to adjust suc-

Dust Bag capacity: 2.5 l

tion power during the operation.

Specifications subject to change without prior

SERVICING

notice.

Replacing the Dust Bag

Never use vacuum cleaner without the Dust

MINIMUM SERVICE LIFE - 5 YEARS

Bag.

The Dust Bag Cover will not close, unless

GUARANTEE

you insert the Dust Bag properly.

Details regarding guarantee conditions can be

obtained from the dealer from whom the appli-

1. Switch vacuum cleaner off and unplug.

ance was purchased. The bill of sale or receipt

2. Press spring plate on Dust Bag Cover (11)

must be produced when making any claim

and open cover. Pull the Dust Bag out.

under the terms of this guarantee.

3. Replace paper Dust Bag. If you are using

the Cloth Dust Bag, clean it from dust and

This product conforms to the

litter. Dust Bag Indicator (4) will show when

EMC-Requirements as laid down

the Dust Bag is full.

by the Council Directive

4. Replace the Dust Bag Cover and push until

89/336/EEC and to the Law

it clicks.

Voltage Regulation (73/23 EEC)

6