Vitek VT-1514 BK: E N G L I S H

5

functions or if there are other damages in

• Then press and hold the cappuccino but-

the unit.

ton (24) for 3 seconds. Let the water run for

• Do not repair the coffee maker by yourself;

80-90 seconds.

always apply to the authorized service center.

• Press the button (24) once again to switch

water supply off.

THE UNIT IS INTENDED FOR HOUSEHOLD US-

• The illumination of control buttons will light

AGE ONLY

up constantly, that means that the unit is

ready for operation and the boiler is clean.

Before using the unit

Attention!

• Make sure that the unit is switched off.

• Do not remove the filter holder (19) during

• Attention! Before using the coffee maker

the unit operation.

for the first time remove the red rubber

• Do not remove the filter holder (19) imme-

plug from the water tank (16).

diately after preparing coffee as there is

• Before using the coffee maker for the first

redundant water and steam pressure inside,

time, wash all removable parts with warm

let the coffee maker cool down completely.

water and dry them.

• To remove the filter holder (19) turn the han-

• Before switching the unit on, make sure that

dle to the left and remove the holder.

the mains voltage corresponds to the voltage

specified on the unit body.

Choosing the appropriate cup

• Remove the water tank (16), fill it with cold

water till the MAX mark and install it back to

Drink Estimated

its place (pic. 1).

volume of the

• Remove the milk tank (11), fill it with cold

ready product

water till the MAX mark as well and install it

Espresso One cup

30-40 ml

back to its place (pic. 2).

Two cups

70-80 ml

• Select one of the coffee filters (20 or 21), and

Cappuccino One cup

170 ml

insert it into the holder (19), matching the

Two cups

280 ml

ledge on the filter with the hole on the holder

Latte One cup

340 ml

(19) and turn the filter clockwise/anticlock-

Two cups

430 ml

wise (pic. 3, 4).

• Install the filter holder into the coffee maker.

Note:

Holder ledges (19) should match the groves

• The cups should be preliminary heated up,

on the boiler (pic. 5) and then turn the filter

to do this, put the cups on the tray (1) while

holder handle (17) to the right till bumping

water heats up in the boiler.

(pic. 6, 7).

• Place a corresponding cup on the respective

Making espresso

tray (3 or 5) and turn the cappuccinator pipe

• Make sure that the unit is switched off.

(2) to the cup using the bar (8) (pic. 8).

• Remove the water tank (16), fill it with cold

• Insert the power plug into the mains socket.

water and install back to its place (pic. 1).

• Switch the coffee maker on by pressing the

• Select one of the coffee filters (20 or 21), and

button (14), the illumination of the buttons

insert it into the holder (19), matching the

(23, 24 and 25) on the control panel will start

ledge on the filter with the hole on the holder

flashing.

(19) and turn the filter clockwise/anticlock-

• When the illumination stops flashing, press

wise (pic. 3, 4).

and hold the espresso button (23) for 3 sec-

• Add ground coffee into the filter: 2 full mea-

onds. Let the water run for 80-90 seconds.

suring spoons - to make two coffee cups

• Press the button (23) once again to switch

and 1 full spoon - to make one coffee cup,

water supply off.

make even and slightly tamp the ground

• Select the washing mode “Cleaning” by turn-

coffee with the back side of the measuring

ing the frothed milk supply knob (9).

spoon (22).

VT-1514_IM.indd 5 07.12.2012 9:29:24