AEG sr 4357 bt: English

36

English

Special safety information

NOTE:

When a mains cable is connected the batteries are auto-

matically switched off.

This device works with a class 1 laser.

CAUTION:

• Different battery types or new and used batteries must

not be used together.

Overview of the Components

• Batteries are not to be disposed of together with

domestic wastes. Dispose of the used batteries at the

1 Handle

relevant collection bin or at your dealer’s.

2 Telescopic antenna

3 CD compartment

WARNING:

4 Tab for opening the CD tray

The batteries shall not be exposed to excessive heat such

5 USB CHARGING connection

as sunshine, fire or the like. Danger of explosion!

6 SKIP-/SKIP+ buttons

7 VOL-/VOL+ buttons

Transport Safety Device, CD Compartment

8 Display

• Open the CD compartment (3) by pulling the lid upwards

9 MODE / MEM / FOLDER button

by the tab (4).

10 PLAY/PAUSE button

• Before operating the machine for the rst time, remove

11 POWER/SOURCE button

the transport safety device from the CD player if it is still

12 STOP / M+ button

in place.

13 USB PLAYBACK port

Volume

Reverse (not shown)

You can set the desired volume with the VOL-/VOL+

AC Mains connection

buttons (7).

PHONES headphone jack

AUX-IN input

Turning device on/ off

Underside (not shown)

• Press the POWER/SOURCE button (11) to turn the device

on.

Battery compartment

• To turn off the device, keep the POWER/SOURCE button

pressed for approx. 3 seconds.

Start-up of the device/introduction

NOTE:

• Select a suitable location for the device, such as a dry,

After about 10 minute without a signal, the device will

flat, non-slip surface on which it is easy to operate the

automatically switch to standby.

machine.

• Ensure that the device is sufciently ventilated!

• Remove the protective lm from the display if it is still

Listening to the Radio

present.

1. Select the radio mode with the POWER/SOURCE button

(11).

Power Supply

2. Completely extend the telescopic antenna. Change its

• Connect the power cable supplied (see battery compart-

position to improve the reception.

ment if necessary) to a properly installed safety power

3. Manual scan for radio stations:

socket and the mains connector AC on the back of the

Briefly press the SKIP-/SKIP+ button (6), until you have

machine.

found the radio station which you are looking for. If you

• Ensure that the voltage is the same as that indicated on

keep one of the buttons pressed down, the device will

the model identification plate.

search to the previous, respectively next radio station.

Preset station:

Inserting the Batteries (not supplied)

1. Search for the desired radio station with the SKIP-/

• Open the lid of the battery compartment on the bottom.

SKIP+ button (6).

• Insert 6 batteries of type UM2/R14 1.5 V. Please ensure

2. To store the radio station, press the MODE/MEM/

that the polarity is correct (see the floor of the battery

FOLDER button (9). The notification “P 01” flashes on

compartment)!

the display.

• If the device is not used for a long period of time, remove

3. Use the SKIP-/SKIP+ buttons to select the desired

the batteries to avoid the spilling of battery acid.

preset location.

• Then close the battery lid.