AEG bqs 5515: English

English: AEG bqs 5515

30

English

10 Grill plate

Note:

11 Cover handle

There are boreholes in the middle of the

12 Handle notch

stand pipes.

13 Sheet

14 Hook

Use the included screws and nuts to t the tray

Without image: Reector plate

(6) here.

Put the device on the stand pipes.

Scope of delivery

Check all stand pipes are securely attached to

the legs.

1x Grill base

4x Legs

Cover (wind deector)

4x Carriage bolds M5

1.

Attach the handle (11) to the cover. Please

4x Wingnuts

mind the notch (12).

1x Tray

2.

Turn the cover over.

1x Reector plate

3.

Use the two sheet metal screws, Ø 3mm, to

1x Heating element with thermostat

fasten the handle inside the cover (see gure

1x Grill plate

b).

1x Plastic mount for hook

4.

Put the sheet (13) into the cover as shown in

1x Cover

the gure.

1x Cover handle

5.

Use the M4 screw, length 20 mm, to attach the

2x Sheet metal screws Ø 3mm, length 9mm

hook (14) and the sheet to the cover.

1x Sheet

Do you want to use the assembled cover as wind

1x Hook

deector?

1x Screw M4, length 20 mm

You may hook the cover into the plastic mount

(2).

Unpacking the device

Grill base

1.

Put the plastic mount (2) into the notch of the

Unpack the device.

grill base.

Remove all packaging materials such as

2.

Put the reector plate into the grill base.

foils, lling material, cable ties and cardboard

3.

Pour 1.5 l of cold water into the grill base, as

packaging.

to cover the plate. You will nd a “MIN”/ “MAX”

Check the scope of delivery.

marking inside the grill base underneath the

plastic mount.

Note:

There might be particles or production remains

Caution:

on the device. We recommend you wipe the

Fill with water until above the reector plate.

enclosure with a damp cloth.

The water bath and the plate will prevent

excessive radiated heat near the base of the

Installation

device. Therefore always barbecue using

water and the tted reector plate.

You may assemble the grill with legs (5) using it

as pedestal grill or without legs using it as table

4.

Put the heating element with thermostat onto

top grill. Please observe gure a.

the grill base.

Pedestal grill

Note:

Take the gill plate (10), heating element with

The thermostat is equipped with a safety switch

thermostat (7) and the reector plate (without

(A). It prevents the operation of the heating ele-

image) from the grill base (3).

ment outside of the grill base.

Turn the grill base upside down.

Check the correct tting of the thermostat in the

Attach the legs (5) with the open end to the

grill base.

stand pipes (4) of the grill base.