AEG SKS51240F0: 7. INSTALLATION

36

www.aeg.com

Problem Possible cause Solution

The temperature in

The temperature regula-

Set a lower temperature.

the appliance is too

tor is not set correctly.

high.

6.1 Replacing the lamp

1.

Disconnect the mains plug from the

mains socket.

2.

Remove the screw from the lamp

cover.

3.

Remove the lamp cover (refer to the

illustration).

4.

Replace the used lamp with a new

lamp of the same power and specifi-

cally designed for household appli-

ances. (the maximum power is

shown on the lamp cover).

5.

Install the lamp cover.

6.

Tighten the screw to the lamp cover.

7.

Connect the mains plug to the mains

socket.

8.

Open the door. Make sure that the

lamp comes on.

3.

If necessary, replace the defective

6.2 Closing the door

door gaskets. Contact the Service

1.

Clean the door gaskets.

Center.

2.

If necessary, adjust the door. Refer

to "Installation".

7. INSTALLATION

7.1 Positioning

Cli-

Ambient temperature

mate

WARNING!

If you are discarding an old appli-

class

ance that has a lock or catch on

SN +10°C to + 32°C

the door, you must ensure that it

is made unusable to prevent

N +16°C to + 32°C

young children being trapped in-

ST +16°C to + 38°C

side.

T +16°C to + 43°C

The appliance shall have the

plug accessible after installation.

7.2 Electrical connection

Install this appliance at a location where

Before plugging in, ensure that the volt-

the ambient temperature corresponds to

age and frequency shown on the rating

the climate class indicated on the rating

plate correspond to your domestic pow-

plate of the appliance:

er supply.