AEG SKD71800F0: WHAT TO DO IF…

WHAT TO DO IF…: AEG SKD71800F0

14

What to do if…

It is important to periodically clean the defrost

water drain hole in the middle of the refrigera-

tor compartment channel to prevent the water

overflowing and dripping onto the food inside.

Use the special cleaner provided, which you will

find already inserted into the drain hole.

Periods of non-operation

When the appliance is not in use for long periods, take the following precautions:

disconnect the appliance from electricity supply

remove all food

4)

defrost

and clean the appliance and all accessories

leave the door/doors ajar to prevent unpleasant smells.

If the cabinet will be kept on, ask somebody to check it once in a while to prevent the

food inside from spoiling in case of a power failure.

WHAT TO DO IF…

WARNING!

Before troubleshooting, disconnect the mains plug from the mains socket.

Only a qualified electrician or competent person must do the troubleshooting that is not

in this manual.

There are some sounds during normal use (compressor, refrigerant circulation).

Problem Possible cause Solution

The appliance is noisy

The appliance is not supported

Check if the appliance stands sta-

properly

ble (all the four feet should be

on the floor)

The appliance does not op-

The appliance is switched off. Switch on the appliance.

erate. The lamp does not

operate.

The mains plug is not connec-

Connect the mains plug to the

ted to the mains socket correct-

mains socket correctly.

ly.

4) If foreseen.

What to do if…

15

Problem Possible cause Solution

The appliance has no power.

Connect a different electrical ap-

There is no voltage in the mains

pliance to the mains socket.

socket.

Contact a qualified electrician.

The lamp does not work.

The lamp is in stand-by. Close and open the door.

The lamp is defective. Refer to "Replacing the lamp".

The compressor operates

The temperature is not set cor-

Set a higher temperature.

continually.

rectly.

The door is not closed correctly. Refer to "Closing the door".

The door has been opened too

Do not keep the door open lon-

frequently.

ger than necessary.

The product temperature is too

Let the product temperature de-

high.

crease to room temperature be-

fore storage.

The room temperature is too

Decrease the room temperature.

high.

The compressor does not

This is normal, no error has oc-

The compressor starts after a pe-

start immediately after

curred.

riod of time.

pressing the COOLMATIC

switch, or after changing

the temperature.

Water flows on the rear

During the automatic defrost-

This is correct.

plate of the refrigerator.

ing process, frost defrosts on

the rear plate.

Water flows into the re-

The water outlet is clogged. Clean the water outlet.

frigerator.

Products prevent that water

Make sure that products do not

flows into the water collector.

touch the rear plate.

Temperature cannot be

COOLMATIC function switched

Switch off COOLMATIC manually,

set .

on.

or wait to set the temperature

until the function has reset auto-

matically. Refer to "COOLMATIC

function"..

The temperature in the ap-

The temperature regulator is

Set a higher/lower temperature.

pliance is too low/high.

not set correctly.

The door is not closed correctly. Refer to "Closing the door".

The product temperature is too

Let the product temperature de-

high.

crease to room temperature be-

fore storage.

Many products are stored at

Store less products at the same

the same time.

time.

The temperature in the re-

There is no cold air circulation

Make sure that there is cold air

frigerator is too high.

in the appliance.

circulation in the appliance.

Оглавление