Pioneer PD-10-K: Connecting up

Connecting up 02

English

Chapter 2:

Connecting up

Caution

• Before making or changing the connections,

switch off the power and disconnect the power cord

from the AC outlet.

• Connect the power cord after all the connections

between devices have been completed.

DeutschFrançais

Analog audio output connections

By connecting this unit’s analog audio output to the

analog audio input of an amplifier, you can use the

amplifier to enjoy analog audio produced from this unit.

Italiano Español Русский

Nederlands

Important

Care in the handling of optical fiber cables

• Do not allow optical fiber cables to be bent at sharp

angles. When storing optical fiber cables, roll in

coils of at least 15 cm diameter.

• When connecting optical fiber cables, align the

connectors correctly and insert fully. If the

RL

ANALOG

orientation of the cable connector is incorrect and

AUDIO INPUT

excessive force is applied in the attempt to fasten

the connector, the connector may be deformed,

preventing the shutter from closing when the cable

is removed.

Digital audio output connections

Note

If desired, the digital audio output from this unit can be

connected to an AV amplifier or digital recording device

• For digital audio output, CDs played on this unit

(CD recorder, MD, etc.).

must produce linear PCM signals with a sampling

• This unit’s DIGITAL OUT terminals do not output

rate up to 44.1 kHz and quantitative bits up to 16

sound from SACD and DSD discs, nor from iPod/

bits (some discs may not be playable depending on

iPhone/iPad devices.

the connected component and environment). For

information about other files, see page 12.

5

En

Using centralized control with other

Plugging in

Pioneer components (PD-30 only)

This unit and other Pioneer components equipped with

CONTROL IN/OUT jacks can be controlled with a single

Important

remote control by aiming the remote toward the signal

• If it is necessary to detach the power cord, first be

receptor on the AV amplifier or other component. This

sure to press the 

/I

STANDBY/ON button on the

also allows remote control of components not equipped

front panel of the unit so the PD-30 is turned OFF or

with a remote sensor, or installed in places where the

the PD-10 is in standby mode before detaching the

component’s remote sensor cannot be accessed.

cord.

• Confirm that the [-OFF-] indicator is not lighted in

the main unit’s front panel display before

disconnecting the power cord. If the power cord is

disconnected while the [-OFF-] indicator is still

lighted, the unit’s settings may revert to factory

defaults.

• When going on a trip or otherwise not using the

unit for an extended period, always disconnect the

power cord from its outlet.

Caution

• Do not use any power cord other than the one

supplied with this unit.

• Do not use the supplied power cord for any purpose

other than that described below.

After you’ve finished making all connections, plug the

unit into an AC outlet.

Note

• For connections use a commercially available

monaural miniplug cord (without resistor).

• When connecting the CONTROL IN/OUT jacks,

commercially available audio cords must also be

used to make analog connections. Merely

connecting the CONTROL IN/OUT jacks alone will

not allow proper system control.

1 Plug the supplied power cord into the

• When a control cord is connected to the PD-30’s

AC IN

socket on the rear of the unit.

CONTROL IN jack, the unit cannot be controlled by

pointing the remote control at the PD-30 (the

2 Plug the other end into AC outlet.

remote sensor is automatically disabled).

PD-30_PWSYXZT8.book 5 ページ ２０１２年５月７日　月曜日　午前１１時３３分