Pioneer FH-X360UB: Connections

4 Turn M.C. to select the system menu

Connections

— Never wire the negative speaker cable directly

function.

to ground.

For details, refer to System menu on page 6.

Important

— Never band together negative cables of multi-

! When installing this unit in a vehicle without

ple speakers.

an ACC (accessory) position on the ignition

! When this unit is on, control signals are sent

Using an AUX source

switch, failure to connect the red cable to the

through the blue/white cable. Connect this

terminal that detects operation of the ignition

cable to the system remote control of an ex-

1 Insert the stereo mini plug into the AUX

key may result in battery drain.

ternal power amp or the vehicle’s auto-anten-

input jack.

na relay control terminal (max. 300 mA

F

F

O

N

12 V DC). If the vehicle is equipped with a

2 Press SRC/OFF to select AUX as the

O

S

A

T

source.

R

glass antenna, connect it to the antenna

T

booster power supply terminal.

Note

! Never connect the blue/white cable to the

ACC position No ACC position

AUX cannot be selected unless the auxiliary set-

power terminal of an external power amp.

ting is turned on. For more details, refer to AUX

! Use of this unit in conditions other than the

Also, never connect it to the power terminal

(auxiliary input) on page 7.

following could result in fire or malfunction.

of the auto antenna. Doing so may result in

— Vehicles with a 12-volt battery and negative

battery drain or a malfunction.

Switching the display

grounding.

! The black cable is ground. Ground cables for

— Speakers with 50 W (output value) and 4 W to

this unit and other equipment (especially,

8 W (impedance value).

high-current products such as power amps)

Selecting the desired text information

! To prevent a short-circuit, overheating or mal-

must be wired separately. If they are not, an

1 Press DISP to cycle between the following:

function, be sure to follow the directions

accidental detachment may result in a fire or

! Source name

below.

malfunction.

! Source name and clock

— Disconnect the negative terminal of the bat-

tery before installation.

This unit

— Secure the wiring with cable clamps or adhe-

If an unwanted display appears

sive tape. Wrap adhesive tape around wiring

Turn off the unwanted display using the proce-

that comes into contact with metal parts to

dures listed below.

protect the wiring.

— Place all cables away from moving parts,

1 Press M.C. to display the main menu.

such as the shift lever and seat rails.

— Place all cables away from hot places, such

2 Turn M.C. to change the menu option

as near the heater outlet.

and press to select SYSTEM.

— Do not connect the yellow cable to the battery

by passing it through the hole to the engine

3 Turn M.C. to display DEMO OFF and press

compartment.

to select.

— Cover any disconnected cable connectors

with insulating tape.

4 Turn M.C. to switch to YES.

— Do not shorten any cables.

— Never cut the insulation of the power cable of

5 Press M.C. to select.

this unit in order to share the power with

other devices. The current capacity of the

cable is limited.

— Use a fuse of the rating prescribed.

1 24

3

5

Section

02

Using this unit

Installation

03

1 Antenna input

2 Fuse (10 A)

3 Power cord input

4 Wired remote input

Hard-wired remote control adapter can be

connected (sold separately).

5 Rear output or subwoofer output

8

En