Vitek VT-3528 BK: ENGLISH
ENGLISH: Vitek VT-3528 BK
ENGLISH
RADIOCLOCK
terminals on the plate in the battery compart-
1. Mode set button “MODE”.
ment. If an AC power failure occurs, the clock
2. Alarm set button «АL».
automatically switches to the battery power
3. Alarm 1 buzzer/radio select button «АL 1».
supply. The clock and the timer memory con-
4. Alarm 2 buzzer/radio select button «АL 2».
tinue running. When the AC power resumes,
5. Thermometer unit (“C/F”) select button
the clock switches back to AC again.
(C°/F°).
6. Infrared sensor.
Getting started
7. Navigation button «
».
Connect the appliance to the outlet AC source.
8. Navigation button « ».
Press the “RESET” button (17) located on the
9. Power (radio) on/off (alarm off) button
back panel of the unit.
«ON/OFF».
- The unit will display full segment, then it will
10. Alarm repeat/timer on button «SNOOZE/
enter the normal mode.
SLEEP».
11. Display.
1. Time and calendar setting
12. Dial scale and pointer.
А. Setting time and calendar:
13. Audio in jack.
- Press «MODE» button (1) and keep depress
14. Volume control.
over 2-3 seconds to enter setup mode,
15. Wave band control.
press «MODE» button (1) to change the
16. Tuning control.
mode cycle as follows:
17. Reset button «RESET».
Normal — Year — Month — Day — 12/24H.
18. Temperature sensor (indoor)
— RTC Hour — RTC Min — Normal.
19. AC power cord.
20. FM antenna wire.
Actions (during data adjustment):
21. Label.
- Keep depressed button
over 2
22. Battery compartment.
seconds to adjust data backward.
23. Speaker.
- Keep depressed button
over 2
24. Minute button for projection unit «M».
seconds to adjust data forward.
25. Hour button for projection unit «H».
26. Time set button for projection unit.
a. Year set mode.
27. Focus adjustment for projection unit.
Time range: 2006г. – 2099г.
28. Projection unit ON/OFF button.
29. Projection unit.
30. Auto display brightness switching button.
Display show year set mode.
Power connection
Plug AC power cord to outlet AC source. The
b. Month set mode.
unit is equipped with the battery back up
system too. It requires 3 x 3Volt CR 2025 flat
lithium batteries (not included). Insert the
battery in the battery compartment, making
certain that the positive and negative (+and-)
Display show month set mode.
battery terminals are attached to correspond
3
3
3528IM.indd 33528IM.indd 3 24.11.2006 15:25:0124.11.2006 15:25:01
