Pioneer MVH-150UBG: Using an AUX source Connections

Black plate (8,1)

Using an AUX source

Connections

— Never wire the negative speaker cable directly

to ground.

1 Insert the stereo mini plug into the AUX

Important

— Never band together negative cables of multi-

input jack.

! When installing this unit in a vehicle without

ple speakers.

an ACC (accessory) position on the ignition

! When this unit is on, control signals are sent

2 Press SRC/OFF to select AUX as the

switch, failure to connect the red cable to the

through the blue/white cable. Connect this

source.

terminal that detects operation of the ignition

cable to the system remote control of an ex-

key may result in battery drain.

ternal power amp or the vehicle’s auto-anten-

Note

na relay control terminal (max. 300 mA

AUX cannot be selected unless the auxiliary set-

O

F

F

O

N

12 V DC). If the vehicle is equipped with a

ting is turned on. For more details, refer to AUX

T

S

(auxiliary input) on page 7.

T

R

A

glass antenna, connect it to the antenna

booster power supply terminal.

Switching the display

ACC position No ACC position

! Never connect the blue/white cable to the

power terminal of an external power amp.

! Use of this unit in conditions other than the

Also, never connect it to the power terminal

Selecting the desired text information

following could result in fire or malfunction.

of the auto antenna. Doing so may result in

1 Press DISP to cycle between the following:

— Vehicles with a 12-volt battery and negative

battery drain or a malfunction.

! Source name

grounding.

! The black cable is ground. Ground cables for

! Source name and clock

— Speakers with 50 W (output value) and 4 W to

this unit and other equipment (especially,

8 W (impedance value).

high-current products such as power amps)

! To prevent a short-circuit, overheating or mal-

must be wired separately. If they are not, an

If an unwanted display appears

function, be sure to follow the directions

accidental detachment may result in a fire or

below.

malfunction.

Turn off the unwanted display using the proce-

— Disconnect the negative terminal of the bat-

dures listed below.

tery before installation.

This unit

— Secure the wiring with cable clamps or adhe-

1 Press M.C. to display the main menu.

sive tape. Wrap adhesive tape around wiring

that comes into contact with metal parts to

2 Turn M.C. to change the menu option

protect the wiring.

and press to select SYSTEM.

— Place all cables away from moving parts,

such as the shift lever and seat rails.

3 Turn M.C. to display DEMO OFF and press

— Place all cables away from hot places, such

to select.

as near the heater outlet.

— Do not connect the yellow cable to the battery

4 Turn M.C. to switch to YES.

by passing it through the hole to the engine

compartment.

5 Press M.C. to select.

— Cover any disconnected cable connectors

with insulating tape.

— Do not shorten any cables.

— Never cut the insulation of the power cable of

this unit in order to share the power with

other devices. The current capacity of the

cable is limited.

— Use a fuse of the rating prescribed.

Section

02

Operating this unit

Installation

03

21

1 Power cord input

2 Rear output or subwoofer output

3 Antenna input

4 Fuse (10 A)

8

En

<QRB3391-A>8