Pioneer DEH-200MP: Installation

Installation: Pioneer DEH-200MP

Section

04

Installation

2 Secure the mounting sleeve by using a

Important

screwdriver to bend the metal tabs (90°)

! Check all connections and systems before

into place.

final installation.

! Do not use unauthorized parts. Use of un-

3 Install the unit.

authorized parts may cause malfunctions.

Dashboard Rubber bush

! Consult your dealer if installation requires dril-

ling of holes or other modifications to the vehi-

cle.

! Do not install this unit where :

it may interfere with operation of the vehi-

cle.

it may cause injury to a passenger as a re-

sult of a sudden stop.

! The semiconductor laser will be damaged if it

Mounting sleeve Screw

overheats. Install this unit away from hot

places such as near the heater outlet.

Removing the unit

! Optimum performance is obtained when the

unit is installed at an angle of less than 60°.

1 Extend top and bottom of the trim ring

outwards to remove the trim ring. (When

reattaching the trim ring, point the side

60°

with a groove downwards and attach it.)

DIN front/rear mount

This unit can be properly installed either from

Front (conventional DIN front-mount) or

Trim ring

Rear (DIN rear-mount installation, utilizing

! It becomes easy to remove the trim ring if

threaded screw holes at the sides of unit chas-

the front panel is released.

sis). For details, refer to the following installa-

tion methods.

2 Insert the supplied extraction keys into

both sides of the unit until they click into

place.

DIN Front-mount

3 Pull the unit out of the dashboard.

Installation with the rubber bush

1 Insert the mounting sleeve into the

dashboard.

When installing in a shallow space, use a sup-

plied mounting sleeve. If there is enough

space behind the unit, use factory supplied

mounting sleeve.

16

En