Pioneer DEH-1800UB: Connections/Installation

11En

Wired remote input (Not available for

vehicle. Connect and when Pin 5

DEH-1800UBA)

is an antenna control type. In another

Hard-wired remote control adapter can

type of vehicle, never connect and

be connected (sold separately).

.

Blue/white

Power cord

Connect to the system control terminal

of the power amp (max. 300 mA 12 V

DC).

Blue/white

Connect to the auto-antenna relay

control terminal (max. 300 mA 12 V DC).

Yellow/black (Not available for DEH-

1800UBA)

If you use equipment with a Mute

function, wire this lead to the Audio

Mute lead on that equipment. If not,

keep the Audio Mute lead free of any

connections.

Speaker leads

White: Front left

White/black: Front left

Gray: Front right

Gray/black: Front right

Green: Rear left or subwoofer

Green/black: Rear left or subwoofer

To power cord input

Depending on the kind of vehicle, the

Violet: Rear right or subwoofer

function of and may be different.

Violet/black: Rear right or subwoofer

In this case, be sure to connect to

and to .

ISO connector

Yel low

In some vehicles, the ISO connector

Back-up (or accessory)

may be divided into two. In this case, be

Yel low

sure to connect to both connectors.

Connect to the constant 12 V supply

terminal.

Red

Accessory (or back-up)

Red

Connect to terminal controlled by the

ignition switch (12 V DC).

Connect leads of the same color to each

other.

Black (chassis ground)

Blue/white

The pin position of the ISO connector

will differ depending on the type of

Power amp (sold separately)

Perform these connections when using the

optional amplifier.

System remote control

Connect to blue/white cable.

Power amp (sold separately)

Connect with RCA cables (sold

separately)

To rear output or subwoofer output

Rear speaker or subwoofer

• Change the initial menu of this unit. Refer

to [SP-P/O MODE] (page 5). The

subwoofer output of this unit is

monaural.

• When using a subwoofer of 70 W (2 Ω), be

sure to connect the subwoofer to the

violet and violet/black leads of this unit.

Do not connect anything to the green

and green/black leads.

DIN mount installation

1 Insert the supplied mounting sleeve

into the dashboard.

2 Secure the mounting sleeve by using a

screwdriver to bend the metal tabs

(90°) into place.

Installation

• Check all connections and systems before

final installation.

• Do not use unauthorized parts as this

may cause malfunctions.

Dashboard

• Consult your dealer if installation requires

Mounting sleeve

drilling of holes or other modifications to

• Make sure that the unit is installed

the vehicle.

securely in place. An unstable

• Do not install this unit where:

installation may cause skipping or

–it may interfere with operation of the

other malfunctions.

vehicle.

When not using the supplied

–it may cause injury to a passenger as a

result of a sudden stop.

mounting sleeve

• The semiconductor laser will be damaged

1 Determine the appropriate position

if it overheats. Install this unit away from

where the holes on the bracket and

hot places such as near the heater outlet.

the side of the unit match.

• Optimum performance is

obtained when the unit is

installed at an angle of less

than 60°.

• When installing, to ensure proper heat

2 Tighten two screws on each side.

dispersal when using this unit, make sure

you leave ample space behind the rear

panel and wrap any loose cables so they

are not blocking the vents.