Pioneer CP-2EX: Cabinet and stand maintenance

4

En

Assembly with a separate speaker system

If you are using a speaker system other than the S-2EX, note

that you will have to use a hand drill (or the like) to make

holes on the speaker base to secure it to the stand. Make

sure the speaker weight does not exceed 29 kg.

After making holes on the speaker base where indicated

(make sure they line up with the screw holes on the speaker

support), secure the speaker to the speaker support using

commercially available wood screws as shown below.

Speaker 

base

Speaker

support

Fastening nut

Commercially 

available wood

screw

Screw holes 

for securing

speaker

Cabinet and stand maintenance

• Use a polishing cloth or dry cloth to wipe off dust and

dirt.

• If the cabinet or stand is very dirty, use a soft cloth

dipped in some neutral cleanser diluted 5 or 6 times

with water. Finally, wipe again using a dry cloth. Do not

use furniture wax or cleaners.

• Never use thinners, benzine, insecticide sprays and

other chemicals on or near the cabinet or stand, since

these will corrode the surfaces.

Specifications

External dimensions ............... 400 (W) x 604 (H) x 513 (D) mm

Weight ..............................................................................  17.8 kg

Supplied accessories

Stand base plates ...................................................................... 2

Speaker supports ....................................................................... 2

Stems .......................................................................................... 4

Spikes (with attached nuts) [SBA6053] ................................... 8

Spike bases [SLA1057] .............................................................. 8

Screws (Bind head, M5xL62) [SBA6050] ................................. 4

Screws (Bind head, M5xL36) [SBA6048] ................................. 4

Screws (Bind head, M6xL40) [SBA6054] ............................... 24

Spring washers [SBE6005] ........................................................ 4

Washers [SBE6006] ................................................................... 4

These operating instructions [SRD6045] ................................. 1

• Specifications and design subject to possible modifica-

tion without notice, due to improvements.

• The product number are listed above in square brackets.

If you want to dispose this product, do not mix it with

general household waste. There is a separate collection

system for used electronic products in accordance with

legislation that requires proper treatment, recovery and

recycling.

Private households in the 25 member states of the EU, in

Switzerland and Norway may return their used electronic

products free of charge to designated collection facilities or to a

retailer (if you purchase a similar new one).

For countries not mentioned above, please contact your local

authorities for the correct method of disposal.

By doing so you will ensure that your disposed product under-

goes the necessary treatment, recovery and recycling and thus

prevent potential negative effects on the environment and

human health.

Part name

• Protector (Bottom)

• Protector (Middle)

• Protector (Top)

• Protector

• Packing case

• Protection sheet

• Protection sheet

• Protection sheet

Part no.

SHA6095

SHA6096

SHA6097

SHA6098

SHG6150

SHC6044

SHC6045

SHC6046

Replacement part numbers

Published by Pioneer Corporation.

Copyright © 2005 Pioneer Corporation.

All rights reserved.