Karcher Monobrosse ultra-haute-vitesse BDP 50-2000 RS Bp Pack: Faults

     - 

6 

Danger

Risk of injury! Before carrying out any tasks 

on the machine, set the main key to "0" and 

remove it. Pull out the battery plug.

Disconnect the power cord of the charger.

Note

Suction turbine (option) overruns after 

shutdown. Carry out maintenance tasks 

only after the suction turbine has come to a 

halt.

In case of faults that cannot be remedied 

using the table below please contact the 

customer service. 

A blinking battery display indicates the fol-

lowing faults. The time sequence of the 

blinking segments indicates the type of 

fault.

Faults

Errors shown by the battery indicator

Number of flashes Fault

Remedy

1

Battery discharged oder battery cable damaged.

Check battery cable, charge battery.

2

Cable to drive motor interrupted.

Inform Customer Service

3

Cable to drive motor shorted.

4

Deep discharge power not reached

Charge battery.

5

--

--

6

Drive attempt while charger is connected.

Remove the power plug from the charger and hook the hold-

er into the appliance.

7

Fault in drive pedal.

Release the drive pedal prior to turning on the appliance.

8

Control faulty.

Inform Customer Service

9

Parking brake fault.

10

Shorted connection on battery connection.

Check the terminals on the batteries.

Once every 5 sec-

onds

Control idle.

Turn the main switch to "0" and turn it back to "1". 

Faults

Fault

Remedy

By whom

Indicator lamp filter bag (option) 

is illuminated

Insert filter bag (option).

Turn the locking device into a horizontal position.

Operator

Indicator lamp polishing pad illu-

minates red

Check if a polishing pad is inserted.

Check the condition of the polishing pad.

Operator

Appliance cannot be started

Insert the battery plug on the device.

Operator

Swivel the top of the appliance down and close the lock.

Operator

Release emergency-stop button by turning.

Operator

Check battery cable for correct sitting.

Operator

Check battery cable for corrosion; clean, if required.

Operator

Battery capacity exhausted; recharge battery.

Operator

Remove the power plug from the charger and hook the holder into the appliance.

Operator

Device does not drive or drives 

only slowly

Release the accelerator, turn key switch to "0", turn key switch to "1", actuate accelera-

tor.

Operator

Reset fuse of control system.

Operator

Set the unlock lever to "drive".

Operator

Charge battery.

Operator

Motor or control overheated; switch off the appliance and let it cool down for 5 minutes. Operator

Remove obstacles from the wheels or push the appliance away from the obstacle.

Operator

Device does not brake

Parking brake deactivated, push the release lever upwards to activate it.

Operator

no or insufficient suction perfor-

mance (option)

Replace filter bag (option).

Operator

The battery indicator blinks

Charge battery.

Operator

See "Faults with display".

Operator

Insufficient polishing result

Clean, turn around or replace the polishing pad.

Operator

Use a polishing pad that is suitable for the application.

Operator

Charge battery.

Operator

Pad does not turn

Reset fuse of brush drive.

Operator

Charge battery.

Operator

Polishing head is not lowered.

Reset fuse of control system.

Operator

17 EN