AEG BSS 4814: English

English: AEG BSS 4814

38

English

Sound Settings (4)

WARNING:

(Preset equalizer function). Different sound modes are availa-

• Ifabatteryleaks,donotrubtheuidintotheeyesor

ble (NORMAL, MUSIC, MOVIE).

the skin. If acid comes into contact with the eyes, rinse

with purified water and seek medical advice if symp-

NOTE:

toms persist.

If necessary, change the EQ setting in your playback unit to

create the best sound.

CAUTION:

Batteries must not be disposed of in the garbage. Please

bring used batteries to competent collection centers or

Adjusting basses and trebles (13)

back to the dealer.

The basses are adjusted with the BASS+/BASS- buttons.

The trebles are adjusted with the TREBLE+/TREBLE- buttons.

Reestablishing factory settings

(3)

Possible malfunctions during the operation may be remedied

For immediate muting of the volume. The currently set

by pressing the RESET button (2).

volume will flash in the display. Press

again to cancel the

• Presstheresetbutton(RESET)ontheremotecontrolto

function.

reset the electronics. The settings made by you and the

stored radio stations will get lost in the process.

Radio mode

General Operation

1. Fully uncoil the wire antenna. Insert the dipole antenna

into the FM ANT jack (4).

Switch device on/off

2. Manual scan for radio stations:

• Turnonthedevicewiththepowerswitchontheback.Set

Briefly press the >>/<< button (6), until you have found

the POWER switch to the “ON” position.

the radio station which you are looking for. If you keep

• Withthe

button (14), you can switch the unit between

one of the buttons pressed down, the device will search

standby and operating mode. When in standby, two bars

totheprevious,respectivelynextradiostation.

are lit in the display.

Preset station:

• Toturnoffthedevice,setthepowerswitchPOWERon

1. Search for the desired radio station with the >>/<<

the back to the “OFF” position. To disconnect the unit

buttons (6).

completely from the mains, pull the mains plug from the

2. To store the radio station, keep the CH+ button (11)

socket.

pressed down for ca. 3 seconds. The notification

“P 01” flashes on the display.

NOTE:

3. Use the CH+/CH- buttons to select the desired

After about 30 minutes without signal, or if the signal is too

preset location.

weak, the device will automatically switch to standby.

4. Keep the CH+ button pressed down again for ca. 3

seconds. The radio station will be stored.

Volume

3. If the reception is too weak and there is interference on

By pressing the

/ buttons (7/10) you can adjust the desi-

the received station, try to improve the reception by

red volume.

altering the position and uncoiling or coiling the antenna.

For FM stations, you can use the ST/MONO button (8) to

Infrared Remote Control

switch between mono and stereo reception. We recom-

For wireless control within a distance of 5 m. If this range de-

mend that you switch to mono in case of bad reception.

creases, the battery has to be replaced. For proper operation

The message “ST” is shown on the display for stereo

mind a clear view between the remote control and the sensor

reception. During reception in mono “SOFF” will appear

on the device.

briefly in the display.

INPUT (1)

Select the preset radio station

Press the INPUT button until the desired operating mode is

The preset radio stations can be selected by repeatedly

shown on the display.

pressing the CH+/CH- button (11).