AEG SR 4367 BT: English

English

51

1. Press the button to switch the device to standby.

Cleaning and Maintenance

2. Press and hold the SLEEP/TIMER button (7 on the remote

control) for approx. 3 seconds. “ “ and “ON TIMER”

WARNING!

will flash in the display. Press the SLEEP/TIMER button

Do not immerse the device in water.

to confirm. After that, the hour digits of the current clock

time will flash.

• Always remove the mains plug before cleaning the

3. Use the and buttons to adjust the settings accord-

machine.

ingly.

• Any marks on the surface can be wiped off with a slightly

4. Press the SLEEP/TIMER button to confirm. The minutes

damp cloth without any additives.

start flashing.

5. Use the and buttons to adjust the settings accord-

Troubleshooting

ingly.

6. Press the SLEEP/TIMER button to confirm. Then use the

Symptoms Course Solution

FUNC button to select the alarm mode: TUNER, USB or

No music

Batteries too weak. Insert new batteries

CARD.

playback.

or operate the device

7. Press the SLEEP/TIMER button to confirm.

with the mains lead.

8. Then use the VOLUME / buttons to adjust the volume

Device cannot

Device crashes and

Disconnect the power

for the alarm function.

be operated.

“hangs”.

supply for 5 sec. Then

NOTE:

switch the device on

• Select a lower volume setting. We recommond

again.

level “03” or level “04”.

No audio signal

The device is not

Ensure that there is a

• Please note that there will be no alarm when select-

during blue

-

registered with the

connection. Register

ing level “00”.

tooth connec-

audio source.

the device with the

tion.

audio source again, if

9. Finally, press the SLEEP/TIMER button. The timer is then

necessary.

set. “ON” will briefly appear in the display. After that,

Volume too low. Increase the volume

“ ” and the current clock time will be displayed.

on the device.

Increase the volume

Turning off the alarm

on the audio source.

To turn off the alarm until the following day, press the

Device can not

Registration does

Check to see if the

button.

be connected.

not work.

audio source supports

the A2DP protocol.

Deactivating the alarm function (in standby mode)

Press the SLEEP/TIMER button. “OFF” will briefly appear in

Audio source is

Turn on the audio

the display and the “ ” icon will disappear.

shut off.

source.

Bluetooth is shut

Turn on the Bluetooth

off on the audio

function on the audio

Delayed switch-off

source.

source.

Do you like to fall asleep with music?

Bluetooth version

Use a different play

-

1. Turn on the device with the desired mode.

is not supported.

back device.

2. Press the SLEEP/TIMER button (7 on the remote control).

The minute setting “90” appears in the display and “

“

Technical Data

will flash.

3. Reduce the time in increments of 10 minutes by pressing

Model: ............................................................................. SR 4367 BT

the SLEEP/TIMER button.

Battery operation: ........................................ 8 x 1.5 V, Type D/R20

4. Once you have adjusted the timer as desired, “ “ will

Power consumption:.................................................................30 W

be lit constantly.

Protection class: ............................................................................... III

• Selecting “OFF” will deactivate this function.

Protection rating: ........................................................................ IP44

Net weight: ................................................................ approx. 3.8 kg

NOTE:

Radio section:

Pressing the SLEEP/TIMER button briefly will display the

Frequency ranges: ...............................FM 87.5 ~ 108.0 MHz

remaining time left until standby is activated.