AEG SR 4367 BT: English

English

47

1. Open the battery compartment.

General operation

2. Replace the cell with a battery of the same type

(CR 2032). Please observe the correct polarity.

NOTE:

3. Close the battery compartment.

• You will find some buttons both on the device and

WARNING:

the remote control. Identical buttons have the same

• Do not expose the batteries to intense heat such as

function.

sunlight, fire or similar. There is a risk of explosion!

• The operation of the device is described by the buttons

• Keep batteries away from children! They are not a toy.

on the device.

• Do not open batteries with force.

• Avoid contact with metallic objects (rings, nails, screws,

Turning device on/off

etc.). There is a risk of short circuit!

• Press the

button (17) to turn the device on.

• Batteries may heat up considerably through a short

• To turn off the device, press the button again. The

circuit or may even ignite. It could result in burns.

control lamp (8) lights up red.

• The battery terminals should be covered with adhesive

tape during transport for your safety.

NOTE:

• Batteries can leak out and can lose battery acid. If the

After approx. 15 minutes without signal or with very poor

device is not used for a longer period of time, remove

signal, the device will automatically switch to standby.

the battery from the remote control.

• If a battery does leak out, do not rub the liquid into your

Volume

eyes or the mucous membranes. In case of contact,

Use the VOL

/ buttons (6) to adjust the volume as desired.

wash your hands, rinse your eyes with clear water, and if

the symptoms persist, consult a doctor.

FUNC (1)

CAUTION:

Press the FUNC button until the desired operating mode is

• Batteries can leak out and can lose battery acid. If the

shown in the display.

device is not used for a longer period of time, remove

the battery from the remote control.

EQ (13)

• Batteries do not belong in the household waste. Please

Press the EQ button repeatedly to select one of the preset

dispose of spent batteries at authorized collection

equalizer sound modes. You may choose from the following:

points or at the dealer.

(FLAT, CLASSIC, ROCK, POP, JAZZ).

MUTE (11 on the remote control)

Setting the clock time

You can quickly shut off the sound using the MUTE button.

The clock time can only be set when the device is in standby

The display will show “MUTE”. Press the button again to turn

mode.

the sound back on.

1. Press the MEM/CLK-ADJ button. “24H” starts flashing in

the display.

INFO (6 on the remote control)

2. Use the

button to select the time display format (24-

Pressing this button during MP3 playback will allow you to

hour or 12-hour format).

turn on or off ID3 tag metadata. Such data appear as scrolling

NOTE:

text in the display.

When selecting the 12-hour format, the display will

show: AM = morning, PM = afternoon.

DISPLAY (10 on the remote control)

• Press this button briefly when the device is switched on,

3. Press the MEM/CLK-ADJ button. The hours start flashing.

in order to briefly show the clock time.

4. Use the

and buttons to adjust the hours.

• Press the button repeatedly when the device is switched

5. Press the MEM/CLK-ADJ button. The minutes start

on, in order to display the current alarm time settings. (See

flashing.

chapter



“Timer function”.)

6. Use the and buttons to adjust the minutes.

NOTE:

Listening to the Radio

The clock time settings will be lost, once disconnected from

the mains supply.

1. Fully extend the telescopic antenna. If necessary, change

the position for a better reception.

2. Select the radio mode with the FUNC button (1). “FM”

will appear in the display.