Karcher Balayeuse KM 75-40 W Bp Pack: Troubleshooting

- 

9

Troubleshooting

Fault

Remedy

Appliance cannot be started

Close appliance hood

Charge the batteries

Check overload fuse

Inform Kärcher Customer Service.

Engine is running but machine is 

not moving

Adjust the Bowden cable of the acceleration drive

Checking the V-Belt

Inform Kärcher Customer Service.

Device comes to halt while climb-

ing a slope

Drive over a path with lesser slope

Check overload fuse

Adjust the Bowden cable of the acceleration drive

Checking the V-Belt

Inform Kärcher Customer Service.

The brush roller stops, fault display 

illuminates red

Turn the main switch to "OFF", check brush for obstructing objects. If applicable, use on a less in-

clined surface. Turn on the main switch. After repeating this process four times, the control will ini-

tiate a forced break of 2 minutes to cool off. During this period the appliance cannot be started.

Machine is not sweeping properly Check roller brush and side brushes for wear, replace if necessary.

Check function of bulk waste flap

Release the Bowden cable of the bulk waste flap (adjustment screw)

Check belts for tension and functioning; replace, if required

Adjust roller mirror

Replacing roller brush

Inform Kärcher Customer Service.

Dust gathers in the machine

Check function of bulk waste flap

Release the Bowden cable of the bulk waste flap (adjustment screw)

Check dust filter, clean or replace

Empty waste container

Replace sealing profile at the waste container

Check the seal on the dust filter

Check sealing strips for wear, adjust or replace as required

Poor cleaning performance at edg-

es

Adjust side-brush lowering

Replace side brush

Lower the side brushes

Check the drive belt of the side brush

Inform Kärcher Customer Service.

Side-brush raising does not func-

tion

Check Bowden cable of the side-brush raising

Inform Kärcher Customer Service.

The new roller brush brushes 

against the waste container

Correct the setting of the sweep track; for this, engage both adjustment levers into the upper boring 

(1...3)

20 EN