Pioneer gm-a6604: Before installing the amplifier

Black plate (12,1)

! The optimal installation location differs de-

Before installing the amplifier

pending on the car model. Secure the ampli-

WARNING

fier at a sufficiently rigid location.

! To ensure proper installation, use the supplied

! Check all connections and systems before

parts in the manner specified. If any parts

final installation.

other than those supplied are used, they may

! After installing the amplifier, confirm that the

damage internal parts of the amplifier, or be-

spare tire, jack and tools can be easily re-

come loose causing the amplifier to shut

moved.

down.

! Do not install in:

— Places where it could injure the driver or

Example of insta llation on

passengers if the vehicle stops suddenly.

the floor mat or chassis

— Places where it may interfere with the dri-

ver, such as on the floor in front of the dri-

1 Place the amplifier in the desired instal-

ver’s seat.

lation location.

! Install tapping screws in such a way that the

Insert the supplied tapping screws (4 mm ×

screw tip does not touch any wire. This is im-

18 mm) into the screw holes and push on the

portant to prevent wires from being cut by vi-

screws with a screwdriver so they make an im-

bration of the car, which can result in fire.

print where the installation holes are to be lo-

! Make sure that wires do not get caught in the

cated.

sliding mechanism of the seats or touch the

2 Drill 2.5 mm diameter holes at the im-

legs of a person in the vehicle as short-circuit

prints either on the carpet or directly on

may result.

the chassis.

! When drilling to install the amplifier, always

confirm no parts are behind the panel and

3 Install the amplifier with the use of

protect all cables and important equipment

supplied tapping screws (4 mm × 18 mm).

(e.g. fuel/brake lines, wiring) from damage.

CAUTION

! To ensure proper heat dissipation of the ampli-

fier, ensure the following during installation:

— Allow adequate space above the amplifier

for proper ventilation.

— Do not cover the amplifier with a floor mat

or carpet.

! Protection function may activate to protect the

amplifier against overheating due to installa-

tion in locations where sufficient heat cannot

be dissipated, continuous use under high-vo-

lume conditions, etc. In such cases, the am-

4

plifier reduces the power output or shuts

down until it has cooled to a certain desig-

nated temperature.

! Place all cables away from hot places, such

as near the heater outlet.

Section

04

Installation

1

3

2

1 Tapping-screws (4mm × 18mm)

2 Drill a 2.5 mm diameter hole

3 Floor mat or chassis

4 Hole-to-hole distance: 338mm (GM-A6604) /

308 mm (GM-A4604)

5 Hole-to-hole distance: 196mm

12

En

<5707000008290>12