Pioneer gm-a5602: Before installing the amplifier

! Check all connections and systems before

Before installing the amplifier

final installation.

WARNING

! After installing the amplifier, confirm that the

! To ensure proper installation, use the supplied

spare tire, jack and tools can be easily re-

parts in the manner specified. If any parts

moved.

other than those supplied are used, they may

damage internal parts of the amplifier, or be-

come loose causing the amplifier to shut

Example of installation on

down.

the floor mat or chassis

! Do not install in:

— Places where it could injure the driver or

1 Place the amplifier in the desired instal-

passengers if the vehicle stops suddenly.

lation location.

— Places where it may interfere with the dri-

Insert the supplied tapping screws (4 mm ×

ver, such as on the floor in front of the dri-

18 mm) into the screw holes and push on the

ver’s seat.

screws with a screwdriver so they make an im-

! Install tapping screws in such a way that the

print where the installation holes are to be lo-

screw tip does not touch any wire. This is im-

cated.

portant to prevent wires from being cut by vi-

2 Drill 2.5 mm diameter holes at the im-

bration of the car, which can result in fire.

prints either on the carpet or directly on

! Make sure that wires do not get caught in the

the chassis.

sliding mechanism of the seats or touch the

legs of a person in the vehicle as short-circuit

3 Install the amplifier with the use of

may result.

supplied tapping screws (4 mm × 18 mm).

! When drilling to install the amplifier, always

confirm no parts are behind the panel and

protect all cables and important equipment

(e.g. fuel/brake lines, wiring) from damage.

CAUTION

! To ensure proper heat dissipation of the ampli-

fier, ensure the following during installation:

— Allow adequate space above the amplifier

for proper ventilation.

— Do not cover the amplifier with a floor mat

or carpet.

! Protection function may activate to protect the

amplifier against overheating due to installa-

4

tion in locations where sufficient heat cannot

be dissipated, continuous use under high-vo-

lume conditions, etc. In such cases, the am-

plifier reduces the power output or shuts

down until it has cooled to a certain desig-

nated temperature.

! Place all cables away from hot places, such

as near the heater outlet.

! The optimal installation location differs de-

pending on the car model. Secure the ampli-

fier at a sufficiently rigid location.

Section

Installation

04

English

1

3

2

1 Tapping-screws (4 mm × 18 mm)

2 Drill a 2.5 mm diameter hole

3 Floor mat or chassis

4 Hole-to-hole distance: 338 mm (GM-A5602) /

228 mm (GM-A3602)

5 Hole-to-hole distance: 196 mm (GM-A5602) /

161 mm (GM-A3602)

11

En