Electrolux EHG30235 x: Adaptation to different types of gas

Adaptation to different types of gas

Injectors replacement

• Remove the pan supports.

!!

!

!!

• Remove the burner's caps and crowns.

• With a socket spanner 7 unscrew and remove the

injectors (Fig. 7), and replace them with the ones

required for the type of gas in use (see table 2).

• Reassemble the parts, following the same procedu-

re backwards.

• Replace the rating label (placed near the gas supply

pipe) with the relevant one for the new type of gas

supply. You can find this label in the package of the

injectors supplied with the appliance.

Should the feeding gas pressure be different or variable

Fig. 7

compared with the required pressure, an appropriate

pressure adjuster must be fitted on the gas supply pipe,

in compliance with the rules in force.

Adjustment of minimum level

To adjust the minimum level of the burners, proceed as

Fig. 8

follows:

• Light the burner.

!!

!!

!

• Turn the knob on the minimum position.

• Remove the knob.

By-pass screws

• With a thin screwdriver, adjust the by-pass screw

(see Fig. 8). If changing from natural gas to liquid

gas, completely tighten clockwise the screw, until

Table 1 : By-pass diameters

a small regular flame is obtained. If changing from

liquid gas to natural gas unscrew about 1/4 turn the

Burner Ø By-pass

by-pass screw, until a small regular flame is obtained.

in 1/100

of mm.

• Finally check the flame does not go out when

quickly turning the knob from the maximum position

to the minimum position.

Rapid 42

This procedure can easily be carried out, anyhow the hob

Auxiliary 28

has been positioned or built in the working top.

Table 2 : injectors

TYPE TYPE OF INJECTORS NOMINAL REDUCED NOMINAL NOMINAL

OF GAS BURNER MARKS POWER POWER POWER PRESSURE

1/100 mm INPUT kW mbar

3

KW m

/h g/h

NATURAL

Rapid 119 3,0 0,75 0,286 - 20

GAS

Auxiliary 70 1,0 0,33 0,095 -

LIQUID

Rapid 86 2,8 0,75 - 202 28-30/37

GAS

Auxiliary 50 1,0 0,33 - 72

80