Electrolux ERZ 28801: CONTROL PANEL
CONTROL PANEL: Electrolux ERZ 28801
4 electrolux
Service
either its refrigerant circuit or insulation
materials. The appliance shall not be dis-
• Any electrical work required to do the serv-
carded together with the urban refuse
icing of the appliance should be carried out
and rubbish. The insulation foam con-
by a qualified electrician or competent per-
tains flammable gases: the appliance
son.
shall be disposed according to the ap-
• This product must be serviced by an au-
plicable regulations to obtain from your
thorized Service Centre, and only genuine
local authorities. Avoid damaging the
spare parts must be used.
cooling unit, especially at the rear near
Environment Protection
the heat exchanger. The materials used
on this appliance marked by the symbol
This appliance does not contain gasses
which could damage the ozone layer, in
are recyclable.
CONTROL PANEL
Fridge Control panel
ON/OFF
ACTION
ACTION
COOL
FREEZE
1 2 3 4 5 6 7
1. Pilot light
for a few seconds and then shows again the
2. ON/OFF switch
inside compartment temperature.
3. Temperature regulator (warmest)
The newly selected-temperature must be
4. Temperature indicator
reached after 24 hours.
5. Temperature regulator (coldest)
Caution! During the stability period by
6. Action Cool light
the first starting the temperature
7. Action Cool switch
displayed can not correspond to the
Switching on
setting temperature. During this time it is
Insert the plug into the wall socket.
possible that the temperature displayed
Press the ON/OFF switch .
is lower than the setting temperature.
The Pilot Light will light up.
Temperature indicator
Switching off
During normal functioning the Temperature
The fridge is shut off by pressing the ON/OFF
indicator shows the temperature inside the
switch until the Pilot light and the Tempera-
fridge.
ture indicator switched off.
Important! Difference between the
Temperature regulation
temperature displayed and temperature
setting is normal. Especially when:
The temperature can be adjusted between
• a new setting has recently been selected.
+2°C and +8°C.
• the door has been left open for a long time.
By pressing the Temperature regulators, the
• warm food has been placed in the com-
current temperature setting flashes on the
partment.
Temperature indicator. It is possible to mod-
ify the setting temperature only with flashed
Action Cool function
indicator. To set a warmer temperature,
The maximum performance is obtained by
press warmest Temperature regulator. To
setting the Action Coolfunction. It’s recom-
set a colder temperature, press coldest Tem-
mended when loading large quantities of
perature regulator. The Temperature indica-
food.
tor displays the newly selected temperature
electrolux 5
You can activate the Action Cool function by
After about 6 hours the Action Cool function
pressing the Action Cool switch.
switches off automatically.
The Action Cool light will light up.
Important! The internal temperature goes
down to +2°C.
Freezer Control panel
ON/OFF
ACTION
ACTION
COOL
FREEZE
1 2 3 4 5 6 7 8 9
1. Pilot light
displayed can not correspond to the
2. ON/OFF switch
setting temperature.
3. Temperature regulator (warmest)
Temperature indicator
4. Temperature indicator
During normal functioning the Temperature
5. Temperature regulator (coldest)
indicator shows the temperature inside the
6. Action Freeze light
freezer.
7. Action Freeze switch
8. Alarm light
Important! Difference between the
9. Alarm reset switch
temperature displayed and temperature
Switching on
setting is normal. Especially when:
• a new setting has recently been selected.
Insert the plug into the wall socket.
• the door has been left open for a long time.
Press the ON/OFF switch .
• warm food has been placed in the com-
The Pilot Light will light up.
partment.
Switching off
Action Freeze function
The freezer is shut off by pressing the ON/
You can activate the Action Freeze function
OFF switch until the Pilot light and the Tem-
by pressing the Action Freeze switch.
perature indicator switched off.
The Action Freeze light will light up.
Temperature regulation
This function stops automatically after 52
The temperature can be adjusted between
hours.
-15°C and -24°C.
It is possible to deactivate the function at any
By pressing the Temperature regulators , the
time by pressingAction Freeze switch.
current temperature setting flashes on the
The Action Freeze light will switch off.
Temperature indicator. It is possible to mod-
Excessive temperature alarm
ify the setting temperature only with flashed
In the event of an abnormal temperature rise
indicator. To set a warmer temperature,
inside the freezer (e.g. power cut) Alarm light
press warmest Temperature regulator . To
will start to flash and a buzzer will sound.
set a colder temperature, press coldest Tem-
After the temperature has returned to nor-
perature regulator. The Temperature indica-
mal, the Alarm light will continue to flash, al-
tor displays the newly selected temperature
though the buzzer has stopped.
for a few seconds and then shows again the
When the Alarm reset switch is pressed, the
inside compartment temperature.
warmest temperature reached in the com-
The newly selected-temperature must be
partment flashes on the Temperature indica-
reached after 24 hours.
tor .
Caution! During the stability period by
If the power has been off for a long time, fro-
the first starting the temperature
zen food should be consumed as quickly as
possible, or cooked and then re-frozen.
Оглавление
- ERZ28801
- Electrolux. Thinking of you.
- CONTROL PANEL
- FIRST USE
- HELPFUL HINTS AND TIPS
- CARE AND CLEANING
- WHAT TO DO IF…
- TECHNICAL DATA
- ENVIRONMENTAL CONCERNS
- Electrolux. Thinking of you.
- KEZELŐPANEL
- ELSŐ HASZNÁLAT
- HASZNOS JAVASLATOK ÉS TANÁCSOK
- ÁPOLÁS ÉS TISZTÍTÁS
- MIT TEGYEK, HA...
- MŰSZAKI ADATOK
- ÜZEMBE HELYEZÉS
- KÖRNYEZETVÉDELMI TUDNIVALÓK
- Electrolux. Thinking of you.
- ПАНЕЛЬ УПРАВЛЕНИЯ
- ПЕРВОЕ ИСПОЛЬЗОВАНИЕ
- ПОЛЕЗНЫЕ СОВЕТЫ
- УХОД И ОЧИСТКА
- ЧТО ДЕЛАТЬ, ЕСЛИ ...
- ТЕХНИЧЕСКИЕ ДАННЫЕ
- ЗАБОТА ОБ ОКРУЖАЮЩЕЙ СРЕДЕ