Pioneer VSX-1025-K: The Advanced MCACC menu 10

The Advanced MCACC menu 10

• EQ ON – You will see the reverb

5If ‘

Advanced EQ Setup

’ is selected, select

English

characteristics of your listening area with

the MCACC memory to be stored, then enter

the equalization performed by this receiver

the desired time setting for calibration, and

1

5

(after calibration).

Note that the EQ

then select

START

.

response may not appear entirely flat due

Based on the reverb measurement above, you

to adjustments necessary for your listening

can choose the time period that will be used

2

area.

for the final frequency adjustment and

Deutsch

calibration. Even though you can make this

When the reverb measurement is finished, you

setting without reverb measurement, it is best

can select Reverb View to see the results on-

to use the measurement results as a reference

screen. See Professional Calibration EQ

for your time setting. For an optimal system

graphical output on page 114 for

calibration based on the direct sound coming

troubleshooting information.

Français

from the speakers, we recommend using the

4 If you selected ‘

Reverb View

’, you can

30-50ms setting.

check the reverb characteristics for each

Use

/

to select the setting. Use

/

to

channel. Press

RETURN

when you’re done.

switch between them.

The reverb characteristics are displayed when

Select the setting from the following time

the Full Auto MCACC or Reverb

Italiano

periods (in milliseconds): 0-20ms, 10-30ms,

Measurement measurements are

3

20-40ms, 30-50ms, 40-60ms, 50-70ms and

conducted.

60-80ms. This setting will be applied to all

Use / to select the channel, frequency

channels during calibration.

and calibration setting you want to check. Use

When you’re finished, select

START

. It will take

/ to go back and forth between the three.

Nederlands

about 2 to 4 minutes for the calibration to

The reverb characteristics graph before and

finish.

after EQ calibration can be displayed by

4

selecting Calibration : Before / After.

Note

After the Acoustic Calibration Equalization is

that the markers on the vertical axis indicate

set, you are given the option to check the

decibels in 2 dB steps.

settings on-screen.

Español

95

En

VSX-1020_SYXCN.book 95 ページ ２０１０年３月１２日　金曜日　午前９時１０分

1 The calibration corresponding to the currently selected MCACC preset will be used when EQ ON is selected. To use

another MCACC preset, press MCACC to select the MCACC memory you want to store.

2 After auto calibration with EQ Type : SYMMETRY (Full Auto MCACC, etc.), the graph for the inferred reverb

characteristics can be displayed by selecting Reverb View. To display the actually measured reverb characteristics

after EQ calibration, measure with EQ ON.

3The After display when measurements have been made using the Full Auto MCACC or Auto MCACC (ALL or KEEP

SP system) function shows the graph for the inferred reverb characteristics after EQ Type : SYMMETRY calibration.

4 The reverb characteristics graph is overwritten each time the reverberations are measured. No Data is displayed if

there is no reverb characteristic data, for example before measurements have been taken.

5 To specify the place where the MCACC memory is to be stored, press MCACC to select the MCACC memory you want

to store.